Broyhill WT-B5231 User manual

Read all instructions before starting
Clear a flat covered space to being
Two adults are recommended for assembly
Note that hardware required is provided for every step
Pay attention to orientation
Letter of the part corresponds to a sticker on the product
Number of the hardware corresponds to its number in the package
Helpful hints provided along the way
All screws should be hand tightened only until the piece is completely assembled. (Start all screws first and then hand tighten
them. This will make the assembly process much easier.) Once the piece is fully assembled, go back and fully tighten all screws
with the tool provided.
Keep all children and pets away from assembly area. Children and pets should be supervised when they are in the area
of the product construction.
Keep assembly area at least 6 feet from any obstruction such as a fence, garage, house, overhanging branches, laundry
line or electrical wires.
Some parts may contain sharp edges. When assembling and using this product, basic safety precautions should always be
followed to reduce the risk of personal injury and damage to the product. Please read all instructions before assembly and use.
The chairs are not to be used for standing purposes and will not function as a stool or step-ladder.
Use on even surface only.
This chair has a weight capacity of 275 lbs (124.7 kgs). Improper use of this product or failure to use as directed may result
in injury.
Not intended for commercial use.
MAINTENANCE:
WARNINGS:
GENERAL BEST PRACTICES FOR ASSEMBLY:
The chairs may be washed on the surface only by using mild soap and water or commercial foaming upholstery cleaner if
necessary. Dry completely. Do not use bleach, acid, or other solvents on the fabric.
We recommend the use of furniture covers when not in use.
Inspect and tighten all of the bolts on a regular basis to ensure the proper performance and safety of your product.
In order to prolong the life and beauty of your product, we recommend that it be stored in a dry and protected area during
off season periods.

PARTS LIST
HARDWARE LIST
x1
Chair Seat & Back
x1
Mechanism
x4
5/16” X 1-1/8" Inner Hexagon Screw
x4
5/16” Open End Washer
x4
5/16” X 7/8” Flat Washer
x1
Five-Star Base with Casters
x1
Gas Lift
x1
Allen Wrench
AB
GFE
D
C
H

HELPFUL HINTS
• Intended for residential use only.
• Separate parts before starting.
• It's better to put the non-woven bag under the chair when installing to prevent the chair from getting dirty.
Place the Chair Seat and Back (A) on it's back. Attach
the Mechanism (B) to the Chair Seat and Back (A) with
Screw (G), Lock Washer (F) and Flat Washer (E). Start
all four screws first. Once started, hand tighten until snug.
Make sure the word "Front" on Mechanism (B) is towards
the front side of the chair. Once all screws are hand tightened,
use Allen Wrench (H) to fully tighten all screws.
Use Allen wrench
to tighten all the
screws.
• Ensure that all bolts are tightened before use. Check and tighten all bolts periodically throughout use of the product.
STEP 1
x4 x4
x4 x1
E F
G H
E
F
A
B
(100%)

STEP 2
STEP 3
C
Insert the gas lift
into the reserved hole
on the mechanism.
Place the five star base on it's wheels. Place the
Gas Lift (C) of the assembled chair into the center
of the base. Assemby is now complete.
D