Broyhill SANDPOINTE User manual

ASSEMBLY INSTRUCTIONS
ITEM#: A102004110/A102004110B1/A102004110B2/
A102004110B3
SKU#: 810545276/810545279/810545278/810545277
6$1'32,17(
;+$5'7233$9,/,21
Need help? We are here for you! 1(866)578-6569 24/7 • Toll Free
SANDPOINTE

0$,17(1$1&(
WHAT IS COVERED?
The limited warranty is extended to the original purchaser and applies to material and manufacturer’s defect provided
the item is maintained with care and used only for personal, residential purposes.
Warranty:6 Months
:$55$17<
:$51,1*6
*(1(5$/%(6735$&7,&(6)25$66(0%/<
• Please read and understand this entire manual before attempting to assemble or install the product.
• Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and
hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.
• The assembled gazebo should be located at least 6 feet from any obstruction such as fence, garage, house,
overhanging branches, laundry lines or electrical wires.
• Some parts may contain sharp edges. Wear protective gloves if necessary, during assembly.
• This unit is heavy. For safety, do not assemble this item alone. Four people are recommended for safe assembly.
• Check all nuts and bolts periodically for tightness and, when required, tighten them again.
• Pay attention to the parts orientation
• Install the gazebo on level ground.Stakes are provided to secure the gazebo to the ground.
• Do not assemble the gazebo on sandy, muddy or loose soil, as stakes do not have enough anchorage in these types
of soil.
• If you wish to secure the gazebo to a wood deck or concrete surface, use anchors suited to these surfaces.
• Snow must be cleared off regularly during snowy days.Remove the snow at the roof top when it is thicker than 2
inches. In order to avoid damage, use a plastic snow rake to remove excessive snow and ice buildup from roof and
keep away from falling debris.
• Any assembly or maintenance of the product must be carried out by adults only.
• Please check your state and local regulations prior to purchasing. Some jurisdictions may require permits for installa-
tion and use. Some special procedures may be valid in your area.
• If any scratch paint, please touch up to prevent rusting
• For outdoor use only.
• Steel components for this gazebo are treated with rust inhibiting paint that protects it from rusting. However, due to
the nature of steel, surface oxidation (rusting) will occur if these protective coatings are scratched. This is not a defect
and thus not covered by the warranty.
• To minimize this condition, it is recommended to use care when assembling and handling the product to prevent
scratching the paint. Should any scratching or damage occur, it is recommended to cover the scratch immediately
with rust inhibiting paint (not included).
• Surface rust can also be easily removed with a very light application of regular cooking oil or WD-40. If surface
oxidation (rusting) occurs and if no measure is taken to prevent this, the oxidation may start dripping onto deck or
patio and caused damaging stains, which may be difficult to remove. This can be prevented if the above-mentioned
measures are taken to keep the product from oxidizing.
• Do not use bleach, acid, or other abrasive cleaners on the roof or frame parts.
• Keep instruction manual for future reference.
• Keep the original packaging to store the gazebo.
• Periodically check and ensure that all bolts are well-tighten during use
2/31

(;3/2'(''5$:,1*
3/31

(;3/2'(''5$:,1*
4/31

3$576/,67
5/31
Label Part Number Description Qty Part Image
A3 Post 4
B3 Base Cover 4
C3 Base 4
D1 3 %eam 1 4
D2 3 %eam 2 4
F1 3 8SSHU6NHZ%HDP 4
F2 3 %RWWRP6NHZ%HDP 4
G P000600749 Middle Beam 4
H P000500620 Large 7op )rame 4
I P000600746 6PDOO7RS
6NHZ%HDP
4
J3 6PDOO7RS,QFOLQHG
%HDP6XSSRUW5RG 4
K P000500619 Small Top
Connector 1
L P005600125 Dome 'ecoration
)rame 4

Small 5oof
'ecorative 3anel
Hook
%LJ5RRI7RS%HDP
%LJ5RRI7RS%HDP
/DWHUDO7UDEHFXODRI
7KH*UHDWHU5RRI
/DWHUDO7UDEHFXODRI
7KH*UHDWHU5RRI
6PDOO&RYHU)RU/DUJH
5RRI
6PDOO&RYHU)RU/DUJH
5RRI
0LGGOH&RYHU)RU
/DUJH5RRI
0LGGOH&RYHU)RU
/DUJH5RRI
/RZHU%DIIOHRI
,QFOLQHG%HDP
Small 7op &over
Small Roof Panel
P005600126
P005800001
P000600752
P000600753
P000600750
P000600751
P000700266
P000700267
P000700268
P000700269
3
P000900044
P000700265
M
N
O1
O2
P1
P2
T1
T2
T3
T4
Q
R
S
4
1
4
4
4
4
4
4
4
4
4
1
4
6/31

%LJ&RYHU)RU/DUJH
5RRI
%LJ&RYHU)RU/DUJH
5RRI
Small 5oof ,nclined
%eam &over 3late
,QFOLQHG%HDP7RS
&RYHU
,QFOLQHG%HDP/RZHU
&RYHU3ODWH
&HQWHU%HDP&RYHU
3ODWH
P000700270
P000700271
P000800120
3
3
P000800123
T5
T6
V1
V2
U
W
4
4
4
4
4
4
7/31

Add
Label Part Number Description Qty Part Image
M6 X 15 Bolt
M6 X 25 Bolt
M6 Flat washer
M6 Nut
M8 Spring
washer
M8 X 20 Bolt
0;%ROW
ƀ8 X 180 Stake
M8 X 30 Bolt
M8 Flat washer
M8 Nut
M6 X 75 Bolt
M6 rubber
washer
M6 Wrench
M8 Wrench
H010020011
H010020015
H050030001
H040010004
H050020016
H010020010
+
H070010003
H010020285
H050030002
H040010010
H010020024
H050050018
H090010017
H090010012
AA
BB
CC
DD
EE
FF
GG
HH
II
JJ
KK
LL
MM
Z1
Z2
57
56
149
8
32
12
20
8
32
56
12
8
16
2
2
3
3
8
1
2
1
1
0
2
3
1
1
1
0
0
+$5':$5(/,67
8/31

• Tools needed and not included：
• How many people needed for the installation work
• Estimate assemble time: 150~180 Minutes
How many people needed for the installation work
+(/3)8/+,176
9/31

Assembled View:
Insert post (A) to base cover (B), secure
base (C) to the post (A) using bolt (BB) and
washer (CC), tighten with wrench (Z1).
67(3
10/31

Assembled View:
Connect beam 1 (D1) and beam 2 (D2) using
bolt (FF), washer (JJ) and nut (KK), tighten
with wrench (Z2).
67(3
11/31

Assembled View:
f
67(3
12/31
32X32X 32X

Assembled View:
CC 1 .
67(3
13/31

Assembled View:
Connect top skew beam (F1) and bottom
skew beam (F2) using bolt (AA) and flat
washer (CC), tighten with wrench (Z1).
67(3
14/31

Assembled View:
Secure assembled skew beams (F1/F2) to
post (A) using bolt (LL) and flat washer
(CC). Connect assembled large top frames
(H) to the assembled skew beams (F1/F2)
using bolt (BB) and flat washer (CC),
tighten with wrench (Z1).
67(3
15/31

Assembled View:
Connect middle beam (G), assembled
large top frames (H) and assembled beam
;ϭϮͿƵƐŝŶŐďŽůƚ;ͿĂŶĚŇĂƚǁĂƐŚĞƌ
;ͿƟŐŚƚĞŶǁŝƚŚǁƌĞŶĐŚ;ϭͿ
67(3
16/31

Assembled View:
Secure lateral trabecula of the greater
roof (P1/P2) to the bottom skew beam
(F2) and the middle beam (G) using bolt
(AA) and flat washer (CC), tighten with
wrench (Z1).
67(3
17/31

Assembled View:
using push pin.
small
top inclined beam support rod (J) using
push pin.
67(3
18/31

Assembled View:
Lock the small roof decorative panel (M)
to the small top inclined beam support
rod (J) as shown.
67(3
19/31

Assembled View:
4X
24X 32X8X
Secure dome decoration frame(L) to
small top inclined beam support rod (J)
and small roof decorative panel (M)
using bolt (BB) and flat washer (CC),
tighten with wrench (Z1).
67(3
20/31