FIXING GUIDE
When fixing your safe, it is important that it is fitted against a solid wall or concrete floor.
For more information and guidence visit our website
Version 2
Sept
2021
www.burtonsafes.co.uk
+44 (0) 1484 663388
USER INSTRUCTIONS - KEYGUARD KEY SAFES
How to open the safe for the first time
ABOUT THE LOCK
This lock requires a 3-8 digit code to open
the lock. You are provided with an emergency
overrride key for this safe - do not keep the keys
inside the safe.
FACTORY CODE: 1-5-9
• Open your safe with the emergency key, follow the steps under
‘How to open your safe with the emergency key’
• Once open, open the battery cover on the inside of the door
• Insert 4x AA batteries
• Keep the safe door open
How to program a code
• Open the safe door
• Press the reset button (This button is located on the inside of the safe
door by the hinges)
• Enter a 3-8 digit code followed by the [B] key
• Your new code is confirmed by 2 beeps and the yellow light flashes twice
• Test your code with the safe door open
How to close the safe
• Ensure that the bolts are fully retracted (if necessary rotate the handle
to retract the bolts)
• Gently push the door shut. Always ensure that there are no objects or
people in the way of the closing door
• Turn the handle until the stop position is reached
Incorrect Entry
• After 3 incorrect entries a warning beep will sound for 20 seconds
• After another 3 incorrect entries a warning beep will sound for
5 minutes
• When the beeps have stopped, try again
How to open the safe with the emergency key
• Remove the emergency key cover on the front of the key safe
• Insert the emergency key into the lock. The key will only fit into the
lock in 1 position. Do not force the key
• Turn the key anti- clockwise then rotate the handle until the bolts are
fully retracted
• Open the safe door
Current supply / Battery change
• This safe requiries 4x AA batteries to operate
• The battery compartment is located on the inside of the safe door
• When the batteries have low power, red lights will flash on the keypad
• Burton Safes recommends Duracell
How to open the safe
• Enter your 3-8 digit code followed by the [B] key
• Rotate the handle until the bolts are fully retracted
• Open the safe door
Setting a master code
• With the door unlocked, input ”00” and press the reset button. Start
setting code when the yellow light goes on
• Input the new master code (3 to 8 digits) followed by the [B] key. It will
be confirmed by 2 buzzer beeps and the yellow light flashes twice, then
setting is done successfully
• If the yellow light flashes with 3 buzzer beeps your code change has not
been successful. Please try again
