camry EB9-4A series User manual

GLASS ELECTRONIC
PERSONAL SCALES
LOW BATTERY INDICATION
Battery power is low. Please install new battery.
Scale overload. (max. weight capacity is
indicated on the scale).
Please step off to avoid damage.
OVERLOAD INDICATION
ADVISE FOR USE & CARE
1.The glass platform will be slippery when it is wet. Keep it dry!
2.Keep standing still during the course of weighing.
3.DO NOT strike, shock or drop the scale.
4.Treat the scale with care as it is a precise instrument.
5.Clean the scale with a damp cloth and avoid water getting inside the scale.
DO NOT use chemical/abrasive cleaning agents.
6.Keep the scale in cool place with dry air.
7.Always keep your scale in horizontal position.
8.If failed to turn on the scale, check whether battery is installed, or battery power
is low. Insert or replace new battery.
9.If there is error on display or can not turn off the scale for a long time, please
take off the battery for about 3 seconds, then install it again to remove soft-fault.
If you can not resolve the problem, please contact your dealer for consultation.
10.Do not use it for commercial purpose.
09EB-002E R1
RE-TEST
Display " " when you step off the scale, means
this weight reading with error. Please re-test.
Battery
Cover
Unit switch
kg/lb/st
Condition 2: if the unit switch is on the back of the
scale,
A. Find unit switch on the back of scale.
B. Pull up and down the unit switch to convert scale
unit between kg-lb-st.

kg
kg
BATTERY
TO REPLACE BATTERY
picture 1
picture 2
CR2032
battery baffle
black tab contact
CR2032
Condition 1: Open battery case cover on the back
of scale, if battery case is the type
shown in picture 1,
A. Bend the small black tab outwards and the
battery will come out .Take note not to bend the
contact.
B. Install new battery by putting one side of the
battery beneath the contact and then pressing
down the other side.
Condition 2:Open battery case cover on the back
of scale, if battery case is the type
shown in picture 2,
A. Take out the used battery with the aid of a
sharp object, as shown in picture 2.
B. Install new battery by putting one side of the
battery beneath the battery baffle and then
pressing down the other side.
STEP 2. Gently step on the scale, then the scale
will be automatically turned on. Stand
evenly on the scale without moving an d
wait until your weight shown on display
is stable and locked.
AUTOMATIC SWITCH OFF
When you step off the scale, it will automatically
switch off. Auto shut-off occurs if display shows
the same weight reading for approximate 8
seconds.
TO CONVERT WEIGHT UNIT
If the scale is with both measuring system of Metric(kilograms) and
Imper ial (pounds, stones), you can convert weight unit as follow:
Condition 1: if the unit switch is inside battery case,
A. Open battery case cover on the back
of scale.
B. Pull up and down the unit switch to convert
scale unit between kg-lb-st.
Unit switch
kg/lb/st
picture 3
Condition 3:Open battery case cover on the back
of scale, if battery case is the type
shown in picture 3,
A. Take out the used batteries (with the aid of a
sharp object, if needed)
B. Install new battery by putting one side of the
battery and then pressing down the other side.
Please take note to the polarity.
OPERATION
Type 1. 1x3V lith ium battery (CR2032). Please
remove the isolationsheet from the
battery contact beforeuse.
Type 2. 2x1.5V AAA batteries(not included)
STEP 1. To make sure accuracy, always put
the scale ona hard and flat surface
like wooden ormarbel floor
(avoid carpet orsoft surface).