Canon CREATIVE PARK Fractional Cake User manual

Fractional Cake : Assembly Instructions
Assembly Instructions
Assembly tip
Necessary utensils
Caution
Notation Key
Three A4 sheets (No. 1 to No. 3)
Writing the number of each section on its back side before cutting out the sections is highly recommended.
(* This way, you can be sure which section is which even after cutting out the sections.)
Fold and crease mountain folds and valley folds before applying glue.
Take your time to cut out each piece carefully.
Trace along the folds with a ruler and an exhausted pen (no ink) to get a sharper, easier fold.
When applying glue to large areas,
take care to prevent warping of paper that may be caused by over-application of glue.
Apply small amounts of glue around the peripheral of the piece or use dual-sided tape to minimize warping.
Please read the Assembly Instructions carefully,
and assemble in order as shown on the pattern sheets.
This papercraft involves using glue, scissors,
and other utensils and materials that may be dangerous
to young children.
Please work somewhere out of reach of young children.
Mountain fold
(dotted line)
Arrow indicates
position for gluing
or insertion.
*The following are used in the assembly instructions.
Indicates reverse side of paper.
Indicates front/reverse of sections to be glued.
Glue the same numbers to each other.
Valley fold
(dashed and dotted line)
Scissors line (solid line)
Guidelines (dotted lines)
Align these guidelines
when gluing pieces together.
Glue spot (Red dot)
Glue reverse side
(Green dot)
Scissors, set square, glue, pencil, used ballpoint pen
Materials for box
To assemble box
Prepare materials by cutting out parts and creasing mountain folds
and valley folds.
Apply glue and insert in order as indicated by numbers.
Indicates front/
reverse of sections
to be glued.

3D diagram
3D diagram
Store fraction boards B and C
in a box.
Cross-sectional view
Fractional Cake : Assembly Instructions

Fractional Cake : Assembly Instructions
Prepare materials. Cut
out the parts and make
mountain folds and
valley folds as indicated.
Materials for
1/8 cake Assembly of 1/8 cake Glue the pieces in numerical order,
curving paper as you work.
Assembly of 1/2 cake Assembly is basically the same as 1/8 cake, with differences explained here.
Glue pieces in numerical order, curving paper as you work.
Assemble 26 pieces of cake. The assembly method is the same for all
six sizes. The example here shows assembly of 1/8- and 1/2-size pieces.
Assemble one 1/8-size piece before assembling the other sizes.
Cut in line
(solid line)
Size
Number
Curl around a rod
approximately
5mm in diameter.
Cross-
sectional
view
Use a toothpick or other
fine-tipped object to apply
glue from outer edge.
Refer to 1/8 cake assembly for instructions
on how to assemble parts 2-2, 2-3, and 2-4.
Total
Curl parts 8-2, 8-3,
and 8-4 as shown in a diagram
*1, then glue in place.
How to play
Place pieces of cake on any of the three fractional
boards to create '1' whole cake.
Use part P29 to create a free-size cake.
Bonus: