Canon PaperCraft White striped longhorn beeetle User manual

1
Before starting assembly:Writing the number of each section on its back
side before cutting out the sections is highly recommended.
(* This way, you can be sure which section is which even after cutting out
the sections.)
Indicates where sections
should be glued together.
Indicates sections that
should be glued first,
then cut out.
http://www.canon.com/c-park/en/
Assembly Instructions
Mountain fold(dotted line)
Make a mountain fold.
Valley fold(dashed and dotted line)
Make a valley fold.
Scissors line(solid line)
Cut along the line.
Cut in line(solid line)
Cut along the line.
Glue spot(Red dot)
Glue parts with the same number together.
Glue spot(Green dot)
Glue within the same part.
Glue spot(Blue dot)
Glue to the rear of the other part.
Glue
The glue spot(colored dot)
shows where to apply the glue.
Tools and materials
Assembly tip
Caution
Scissors, set square, glue(We recommend stick glue), pencil, used
ballpoint pen, toothpicks, tweezers, (useful for handling small parts)
Before gluing, crease the paper along mountain fold and valley
fold lines and make sure rounded sections are nice and stiff.
Glue, scissors and other tools may be dangerous to young children
so be sure to keep them out of the reach of young children.
Assembly Instructions : Three A4 sheets (No.1 to No.3)
*This model was designed for Papercraft and may differ from the original in some respects.
*Hint: Trace along the folds with a ruler
and an exhausted pen (no ink) to get a sharper, easier fold.
*Build the model by carefully reading the Assembly Instructions, in the parts sheet page order.
View of completed model
2
3
1
4
Assembled parts 2 - 3
©Canon Inc. ©Y. Watanabe
White striped longhorn beetle : Assembly Instructions

2
©Canon Inc. ©Y. Watanabe
White striped longhorn beetle : Assembly Instructions
5
15
Assembled parts 1 - 8
6
78
9
16
Assembled parts 1 - 4
11
13
14
12
10
Fold parts 9 - 14 in two and glue both sides togeth-
er before cutting out these parts.

3
22
21
19
Finished!
20
18
17
Glue parts 17, 18, 19, 20, 21, and 22 in place
as shown in this illustration.
©Canon Inc. ©Y. Watanabe
White striped longhorn beetle : Assembly Instructions