3 USE
3.1 Handling and transport
The machine are easily transportable both in packed and freeform. It is recommended
to pay attention to the overhead lines of the machine when it is transported for its use.
3.2Before use
Before the machine is put into operation, the operator must have read and understood
all the parts of this manual and in particular what is reported in Chapter 2 dedicated to
safety.
Before using the machine for the first time:
- Familiarize yourself with the control devices and their functions,
- Check that all machine components subject to wear or deterioration are intact,
- Verify that all safety systems are intact and that the fixed crankcases are in the
correct position.
3.3 Assembly and connection
To mount the machine on the pneumatic rod, turn the thread clockwise until it locks. To
disassemble rotate in the opposite direction.
Once mounted on the rod and before proceeding with the ignition, make sure that
the compressor pressure is from 6 to 8 bar, higher pressures could cause greater
wear of the machine components.
3.4 Use of the machine
To start the machine you need to connect the handle to the compressor.
Pressing the lever on the handle starts the machine. The release of the lever blocks the
operation. This device is to guarantee the safety of the operator who in case of
accidental fall allows the blocking of the moving part.
Once started, approach with the comb to the branch to be shaken. Pay attention to
branches especially laden with fruits. Hold the machine firmly with both hands and always
work in stable conditions on the legs.
NB: Avoid touching moving parts of the machine in any way.
To turn off the machine, simply close the tap in the opposite position to the one of ignition.
In the event that the machine is temporarily unused, it is important to place it in a stable
horizontal position, in order to avoid risky falls.
Directions for use:
- The wear of the mechanical components of the machine is closely related to the
way the machine is used. Therefore, avoid insisting on the branch to be shaken
until the machine stops, this would cause a mechanical overload of the
components. Try to limit the stops as much as possible for too much effort, this
extends the life of your tool!
- In order to avoid dangerous overloads of effort that can cause damage to the comb,
it is advisable to intersperse the shaking action with regular pauses, in
order not to stress the tool beyond the standards for which it was
designed and tested.
- To reduce the effect of vibrations on the hand-arm system, it is
recommended to intersperse the use of the comb with 15-minute
pauses every two hours of use
4. MAINTENANCE AND CLEANING
