Castles Technology SATURN1000 S1F2 MOB User manual

SATURN1000 S1F2 MOB POS Terminal
Book 2
User Manual
S1F2
Version 1.2
Mar. 2022
CRT-S1-04-02-V1.2-CB-FCC-IC-UL-cUL
CASTLES TECHNOLOGY
Castles Technology Co., Ltd.
6F, No. 207-5, Sec. 3, Beixin Rd., Xindian District,
New Taipei City 23143, Taiwan R.O.C.
http://www.castech.com.tw

Castles Technology Co., Ltd. Pg. 2
WARNING
Information in this document is subject to change without prior notice.
No part of this publication may be reproduced, transmitted, stored in a retrieval system,
nor translated into any human or computer language, in any form or by any means,
electronic, mechanical, magnetic, optical, chemical, manual, or otherwise, without the
prior written permission of Castles Technology Co., Ltd.
All trademarks mentioned are proprietary to their respective owners.

Castles Technology Co., Ltd. Pg. 3
Revision History
Version
Date
Descriptions
Author
1.0
2021.12.23
Initial creation.
John
1.1
2021.12.21
1. Update cover from S1F2 to S1F2 MOB
2. Add 5G caution for FCC
3. Add 5G caution for IC
4. Update UL Adapter caution
John

Castles Technology Co., Ltd. Pg. 4
Contents
1. Introduction.................................................................................................................. 5
2. Hardware Setup............................................................................................................ 6
2.1. Parts of the Terminal ........................................................................................... 6
2.2. Insert Battery ..................................................................................................... 10
2.3. Insert SAM Card ................................................................................................ 12
2.4. Insert GSM SIM Card ........................................................................................ 13
2.5. Insert Micro SD Card ......................................................................................... 14
2.6. Insert Paper Roll................................................................................................ 15
3. Appendix .................................................................................................................... 16
3.1. FCC................................................................................................................... 16
3.2. IC....................................................................................................................... 17
3.3. UL / IEC 62368-1............................................................................................... 18

Castles Technology Co., Ltd. Pg. 5
1. Introduction
This document provides a guideline for operating and configuring Castles SATURN1000
terminal.
The scope of this document includes setting up the terminal, basic operation, application
lifecycle, and some advanced features.
Regulatory instruction of usage
●Before using the terminal, please check has it been disassembled, modified, or showed
abnormal situation. If yes, please do not use.
●Please stay away from strong electromagnetic waves.
(Example) Microwave ovens, magnets, shoplifting prevention devices, high-voltage
wires, automatic doors, communication antennas, etc.
●Condensation can occur when moving from a cold place to a warm place. If
condensation occurs, do not use the unit until the connected water droplets evaporate.
●Static electricity may occur in some places (such as where you use a carpet).
●Please do not leave it in the sun for a long time.
●Please operate the unit carefully as it is a precision instrument. Do not apply impact,
drop or heavy objects on top of the unit.
●Do not attach dust, oil, etc. to a part of the power terminal. Also, please do not scratch.

Castles Technology Co., Ltd. Pg. 6
2. Hardware Setup
2.1. Parts of the Terminal
Front
1. Paper Roll Box
2. LCD Display (5.5”)
3. Smart Card Reader
4. Magnetic Stripe Reader
5. Contactless Card Landing Zone
1
2
3
5
4

Castles Technology Co., Ltd. Pg. 7
Rear
Without Barcode Scanner With Barcode Scanner
6. Rechargeable battery cover
7. The Connector of charger
8. Product label
9. Speaker
6
7
8
9
6
7
8
9
SATURN1000
Rechargeable Battery

Castles Technology Co., Ltd. Pg. 8
Rear
Without Barcode Scanner With Barcode Scanner
10. Micro SD Card Slot
11. SAM slots 1-2
12. GSM SIM card slots 1-2
13. Barcode Scanner
14. Camera
15. Photo-flash
13
14
10
11
12
10
11
12
15
14
15

Castles Technology Co., Ltd. Pg. 9
Left side
16. Power Button
17. DC Jack
18. USB Type C slot
19. Headphone Jack
20. LED indicator
Green light : Battery fully charged
Orange light: Battery charging function activated
21. Microphone
16
17
18
19
20
21

Castles Technology Co., Ltd. Pg. 10
2.2. Insert Battery
Step 1: Slide down and remove the battery cover.
Step 2: Insert the battery into the compartment.
Step 2-1: Install the battery to the contact point(Make sure pin is inside the slot.)
Step 2-2: Press down the battery.
Step 3: Reverse the operation of step 1 to install the battery cover.
Note: Please confirm the battery is installed before power on the terminal.
Step 1
Step 2
Step 2-1
Step 2-2

Castles Technology Co., Ltd. Pg. 11

Castles Technology Co., Ltd. Pg. 12
2.3. Insert SAM Card
Step 1: Remove battery cover and battery
Step 2: Insert SAM card into the desired slot.
SAM 1 & 2:
Gold contact is on the lower side of the card and facing down.
Step 3: Reverse the operation of step 1 to install the battery cover.
Bottom: SAM 1
Upper: SAM 2

Castles Technology Co., Ltd. Pg. 13
2.4. Insert GSM SIM Card
Step 1: Slide down to remove battery cover/back cover.
Step 2: Open SIM socket and insert GSM SIM card into the desired slot.
SIM 1 & 2:
Gold contact is on the lower side of the card and facing down.
Step 3: Reverse the operation of step 1 to install the battery cover.
Bottom: SIM 1
Upper: SIM 2

Castles Technology Co., Ltd. Pg. 14
2.5. Insert Micro SD Card
Step 1: Slide down to remove battery cover/back cover.
Step 2: Place the Micro SD memory card.
Step 3: Reverse the operation of step 1 to install the battery cover.
Open the metal
cover
Push down the
metal cover
Place the micro
SD card
Close and push up
the metal cover

Castles Technology Co., Ltd. Pg. 15
2.6. Insert Paper Roll
Step 1: Pull up the paper roll box handle.
Step 2: Open paper roll cover gently.
Step 3: Insert paper roll as the direction shown.
Paper specification
Width: 57mm
Outside diameter: 40mm
Step 1
Step 3
Step 2

Castles Technology Co., Ltd. Pg. 16
3. Appendix
3.1. FCC
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:
⚫Reorient or relocate the receiving antenna.
⚫Increase the separation between the equipment and receiver.
⚫Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
⚫Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
⚫Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
⚫This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Radiation Exposure Statement:
The product comply with the FCC portable RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as described in this manual. The further RF
exposure reduction can be achieved if the product can be kept as far as possible from the
user body or set the device to lower output power if such function is available.
Note: The country code selection is for non-US model only and is not available to all US
model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation
channels only.
Operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for
harmful interference to co-channel mobile satellite systems.

Castles Technology Co., Ltd. Pg. 17
3.2. IC
Industry Canada statement
This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) le dispositif ne
doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage
reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable.
Radiation Exposure Statement:
The product comply with the Canada portable RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as described in this manual. The further RF
exposure reduction can be achieved if the product can be kept as far as possible from the
user body or set the device to lower output power if such function is available.
Déclaration d'exposition aux radiations:
Le produit est conforme aux limites d'exposition pour les appareils portables RF pour les
Etats-Unis et le Canada établies pour un environnement non contrôlé.
Le produit est sûr pour un fonctionnement tel que décrit dans ce manuel. La réduction aux
expositions RF peut être augmentée si l'appareil peut être conservé aussi loin que possible
du corps de l'utilisateur ou que le dispositif est réglé sur la puissance de sortie la plus faible
si une telle fonction est disponible.
Caution :
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems;
(ii) where applicable, antenna type(s), antenna models(s), and worst-case tilt angle(s)
necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in
section 6.2.2.3 shall be clearly indicated.
Avertissement:
Le guide d’utilisation des dispositifs pour réseaux locaux doit inclure des instructions
précises sur les restrictions susmentionnées, notamment :
(i) les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour
une utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux
systèmes de satellites mobiles utilisant les mêmes canaux;
(ii) lorsqu’il y a lieu, les types d’antennes (s’il y en a plusieurs), les numéros de modèle de
l’antenne et les pires angles d’inclinaison nécessaires pour rester conforme à l’exigence de
la p.i.r.e. applicable au masque d’élévation, énoncée à la section 6.2.2.3, doivent être
clairement indiqués

Castles Technology Co., Ltd. Pg. 18
3.3. UL / IEC 62368-1
⚫Battery
EUT highest specified charging temperature: 45°C (+3°C/-3°C); lowest specified
charging temperature: 0°C (+3°C/-3°C)
⚫The product's operation temperature at 0-40°C.
⚫Input Rating
5V/2A (supplied by Adapter)
⚫Warning:
Power cord shall be connected to a socket-outlet with earthing connection.
⚫Warning:
Risk of explosion if battery is replaced by an incorrect type. Dispose of expended
battery in accordance with local disposal regulations.
⚫Warning:
This product is intended to be supplied by a Listed Power Adapter ""L.P.S."" (Or
""Limited Power Source"") and is rated at 5 Vdc, 2 A min., Tma = 40 degrees C.
●Attention:
le cordon d'alimentation doit être branché sur une prise secteur avec mise à la
terre.
●Attention:
Risque d'explosion si la batterie est remplacée par une de type incorrect Éliminer
la pile usagée conformément à la réglementation locale en vigueur.
●Attention:
Le produit est destiné à être alimenté par un adaptateur secteur répertorié «
L.P.S. » (ou ""Source d'alimentation limitée"") et est évalué à 5 Vdc, 2 A min.,
Tma = 40 degrés C.