CB2 stern User manual

Customer Service 800.606.6252 | Latest instructions available at www.cb2.com
Made in India - r06 Page 1 of 2
stern COUNTER TABLE
hardware
components
tools required
Thank you for purchasing the Stern Counter Table.
This page
lists all the contents included in the box.
Please take the time
to identify the hardware as well as
the individual components
to this product. As you
unpack and prepare for assembly, place the contents on
a carpeted or padded area to protect them from
damage.
Note: 2 people are recommended to safely assemble this
product.
Missing hardware?
Please call 800.606.6387 for replacements.
STEP 1) Carefully place tabletop onto a clean,
padded surface. Locate letters on each leg frame
and tabletop. Attach each leg frame to
corresponding letter of tabletop with 2 washers
and 2 hex bolts as shown. Secure, but do not
over tighten, bolts using a hex wrench.
STEP 2) At this point secure each leg frame to
tabletop with 3 washers and 3 hex bolts as
shown.
With the assistance of another adult, carefully
position table upright.
Assembly is now complete.
leg frame
STEP 1
10 - flat
washers
10 - hex bolts
2 - leg frames
(1 leg frame A, 1 leg frame B)
hex wrench (included)
1 - tabletop
leg frame
tabletop
NOTE: Do not over
tighten the bolts.
STEP 2
A
A
B
B
B
A

Customer Service 800.606.6252 | Latest instructions available at www.cb2.com
Made in India - r06 Page 2 of 2
stern COUNTER TABLE
cleaning and care
-Clean surfaces with a dry or damp
soft cloth.
-Do not use abrasive cleaners.
-Re-tighten bolts as necessary.
-Avoid direct sunlight if possible.
-Protect from heat and liquids.
-Do not place hot objects on surface.
-For indoor use only.
-Do not place rubber objects or other
marking objects on surface.
-Do not leave spills unattended as it
may damage the finish. Wipe
immediately.
NOTE: Please do the following if your table is
not level.
With the assistance of another adult, adjust
levelers of each leg as necessary.
leg frame
leveler
method to adjust levelers on table