Celexon Economy 1090019 User manual

Operating instructions
celexon tripod screen Economy
Thank you for purchasing this product.
For optimum performance and safety, please read these instructions carefully
before connecting or operating this product. Please retain these instructions for future
reference.
Version: 32422_071

1
The purpose of these operating instructions is to familiarise you with the operation of
this product. Therefore, keep these instructions in a safe place so that you can refer to
them at any time.
• Before installation or use, please refer to the enclosed data sheet with
additionalfurther safety and usage instructions.
• Do not start installation until you have read and understood the complete
operating instructions.
• Carry out the installation with another person to ensure safe installation.
• Remove the product from its packaging and remove all packaging materials. Make
sure that there is no packaging material on or in the product. If you notice any
damage to the packaging, also check whether there is any damage to the pro-
duct. If you notice any external damage to the unit or any unexpected or unu-
sual functioning, do not continue to use the product. Contact the dealer from
whom you purchased the product or celexon directly (Web: www.celexon.co.uk,
Mail: [e-mail]) for further information.
• This product is intended for indoor use and storage. Occasional outdoor use is pos-
sible and may only be carried out under supervision, in a max. wind force 1 and in
dry conditions.
• The use of the screen and accessories is prohibited for children under 16 years of
age.
• Ensure that children do not play with the appliance or stay in the vicinity without
supervision.
• Conversion or modication of the product impairs product safety.
• Caution: Risk of injury! Never open the product without authorisation. Never carry
out repairs yourself!
• Do not use the product in the vicinity of escaping gas, water or in a dusty environ-
ment.
• Handle the product with care. It can be damaged by knocks, blows or falling from a
from even a small height.
• Keep the product away from moisture and heat.
• Never immerse the product in water or other liquids.
• Only use the product in its intended manner. Any other use may result in damage to
the product or its surroundings.
• Caution: Risk of injury! The unit closes ush and rmly when retracted. Keep n-
gers, hands or other small parts away from the opening.
WARNINGS

2
• Failure to follow the above instructions may result in personal injury and damage to
the product or equipment, or devices connected to it. Incorrect installation or use
may also invalidate the warranty.
• If you are unsure about the use of the product, please contact your speci-
alist personnel, your dealer or celexon directly (Web: www.celexon.co.uk,
Mail: [e-mail]).
• Technical changes and errors expected.
The manufacturer accepts no responsibility for damage to property or personal injury
if the screen is used outside the recommended specications, or in the event of impro-
per installation. Do not use this screen in the vicinity of heaters or air conditioners. If
possible, do not use the product in direct sunlight or in front of a window. Due to the
temperature-sensitive material of the screen the projection screen fabric may become
deformed (atness).
We recommend that you wait approx. 2 hours after delivery before installing the projec-
tion screen fabric. This way the projection screen can acclimatise, especially if it is moved
from a cold to a warm environment.
Please avoid any stains on the surface of the screen. These may not be able to be re-
moved.
DISCLAIMER
The information in this document is subject to change without notice by the
manufacturer. Changes will be added to subsequent versions of this manual.
The manufacturer does not guarantee or warranty for the correctness of the
information in this document.

3
NEVER clean the screen with alcohol or other cleaning agents containing sol-
vents. Use only a soft and clean cloth. If necessary, use a mild soap solution
to remove dirt from the surface. Avoid contact with sharp or pointed objects.
These could permanently damage the projection screen fabric. For further in-
formation, please refer to the enclosed projection screen instructions.
CARE INSTRUCTIONS
1. Do not position or store the screen in areas where direct sunlight shines
on the screen.
2. Keep the screen fabric free of dirt or particles so as not to damage the sur-
face of the screen and spoil the projection result. If the screen is dirty, clean
it with a soft cloth and lukewarm, mild soap solution. Then wipe again with
clean water so that no soap residue remains. The fabric must not be soa-
ked, but only wiped with a slightly damp cloth. It must be completely dry
before being retracted.
3. Please do not use petrol, thinners or similar solvents to clean the fabric.
IN THE BOX
1 x Tripod screen

4
PARTS
INSTALLATION NOTES
Install the screen in a position that is completely visible to all viewers. The op-
timum installation height corresponds to the position of the viewers centrally
to the screen. Ideally the viewer‘s eye level will be level with the lower third of
the screen surface.
Do not place the projection screen in walkways or in fast-moving areas to
prevent it from falling over and injuring people.
1. Do not touch the screen fabric while you are extending or retracting the
screen.
2. Do not place the screen on unstable or uneven surfaces, the screen could
fall or tip over. Be careful children are not left alone in the room with the
screen.
3. When the screen is not in use, place it vertically on the stand and lean it
against a wall, for example, to prevent it from falling over.
4. Do not hang any objects on the screen.
Tripod hook
Upper bar
Screen fabric
Clamping nut
Housing
Clamping handle / Carry handle
Tripod bar
Tripod feet

5
SETTING UP THE SCREEN
STEP 1:
Place the screen vertically on the tripod feet and
release the tensioning lever on the carrying handle.
STEP 2:
Hold the screen by the handle and lift the case
slightly while pulling the tripod feet downwards as
far apart as possible and place the screen on them.
For sizes over 200cm, 2 people are required to set
up the screen.
STEP 3:
Hold the screen by the carrying handle and rotate
the stand 90° so that the screen can be extended
upwards. Adjust the housing to the desired height
and tighten the tensioning lever. Do not release the
housing by the carrying handle until the tension lever
is tight.
STEP 4:
Loosen the tensioning nut, turn the stand hook forward
and carefully pull the cloth vertically upwards. Hang
the fabric on using the loop in the centre of the upper
bar.
STEP 5:
With one hand, grasp the back rod of the stand, with the other hand the
carrying handle and adjust the screen to the desired height. Then screw the
tensioning nut hand-tight again.
STEP 6:
The integrated keystone bracket is located at the
top of the stand rod. This can be used to correct for
angled projection if required.

6
STEP 1:
Unhook the retaining bracket at the top of the screen from the stand hook
and slowly guide the screen back into the housing until the screen is fully
retracted.
STEP 2:
Now loosen the tensioning nut on the stand rod and push the rod back to-
gether to its original length. Tighten the tensioning nut carefully again.
STEP 3:
Loosen the tensioning lever on the carrying handle and return the housing to
its original position, then secure the tension lever.
STEP 4:
Rotate the enclosure 90 degrees back to the vertical position. It may be
necessary to Release the tension lever again allowing the enclosure to move
upwards so that it does not hit the ground when turning. Afterwards tighten
the lever again.
STEP 5:
Fold the tripod feet together.
PACKING AWAY THE SCREEN
At the upper end of the housing end cap you will nd a
round recess into which the tripod hook is inserted for
transport. To do this, loosen the rod and insert the hook
into the recess. Afterwards, the tensioning nut should be
tightened again and the screen can be transported via
the carrying handle.
If you use a tripod bag from celexon (sold separately)
the rod does not have to be inserted into the inlet for the
screen to t into the bag.
celexon Europe GmbH | Gutenbergstraße 2 | 48282 Emsdetten | DE