Celexon Expert User manual

celexon.
TM
www.celexon.com
celexon.
TM
Installaon Guide
celexon screen
Manual Expert
Please read the installaon instrucons carefully
before using the screen.
Please keep for future reference

1
Installation
Install the screen so that it is central for most viewers. When fully extended,
please ensure that the lower third is about eye level. The screen can be wall or
ceiling mounted (You may be required to purchase screws and wall plugs
suitable for your specic building material, use Ø ca.5x35mm screws).
Ceiling installation
Mark out two parallel lines with the appropriate hole spacing of the mounting
brackets on the ceiling. Ensure that they are aligned and drill the holes. Screw the
mounting brackets to the ceiling (see g 1). Then hang the screen on the brackets
(see g 5) and tighten the safety screw underneath the screen (see g 6).
Fig 1: Mounting brackets attached to
ceiling
Fig 2: Side view of ceiling installation
Fig 3: Mounting brackets attached
to wall
Operating instructions
To lower the screen:
Pull the fabric down to the desired position using
the handle on the weighted bar (g 1). Wait for
about 3 seconds and slowly release the handle
until the screen has stopped. The screen can be
stopped approx. every 10cm.
To retract the screen:
Pull the fabric down, approx. 3-5cm to disengage
the locking mechanism (g 2) and pause for a
second. Once the locking mechanism has been
disengaged, the screen will pull back automatically
into its housing (slow-return-mechanism).
2
Wall installation
Mark out two parallel lines with the appropriate hole spacing of the mounting
brackets on the wall. Ensure that they are aligned and drill the holes. Screw the
mounting brackets to the wall (g 3). Next, hang the screen on the brackets (see g
5) and tighten the safety screw underneath the screen (see g 6).
Fig 4: Mounting
bracket
Fig 5: Side view of screen
attaching to mounting
bracket
Fig 6: Safety screw