Charge Amps Halo Wallbox User manual

HALO Wallbox™
INSTALLATION GUIDE
This guide is for TN and IT net.
The installation must be performed by an authorised electrician.
The installation must be protected by a type A RCD (DC protection is integrated in the HALO).
1. Mount the wifi antenna under-
neath the HALO as the picture.
3. Mount the HALO and ensure
mounting is sealed closely to the
wall to prevent water leaking into
the housing.
2. Drill holes for the HALO using
the drill template included and a
spirit tool, plug the holes. Make
sure you are mounting the HALO
on a flat surface.

5. Mount the lid using a H4 hex key.
3. If you have removed the ca-
bles previous to mounting, en-
sure you click the antenna back
into the white holders to pre-
vent it from getting damaged
when mounting the lid.
See picture.
4. If choosing to let all the ca-
bles stay connected to the lid
as you mount the HALO to the
wall, ensure you hold the lid
steady and not letting it hang in
the cables.

1. Power supply
2. Wifi- antenna
3. LED connection
4. EV connector
5. Schuko connection
1
1
2
2
3
3
4
4 5
5
HALO Wallbox™ 1-Phase TN and IT Net
HALO Wallbox™ 3-Phase Only TN Net
L1
L2
L3
N
PE
Recommended for load
balancing purposes
L1
L2
PE
(TN Net)
(IT Net)
L1
L2
L3
N
PE
(TN Net)

HALO Wallbox™
TECHNICAL INSTALLATION DATA
CHARGING CURRENT
VOLTAGE
FREQUENCY
ENVOIRONMENT CONDITIONS
MOUNTING METHOD
ELECTRIC SHOCK PROTECTION
CHARGING MODE
FAULT CURRENT PROTECTION
OVER-CURRENT PROTECTION
VENTILATION CONTROL
NOTE
3.7kW: 1x16 A
11kW: 3x16A
7.4kW: 1x32A
100-240 V
50/60 Hz
Indoor and Outdoor <95% humidity
Mounted on flat surfaces
Class 1 equipment
Mode 3
Fault current protection device (RCD)
shall be mounted externally on supply-
ing network. The RCD shall be of type
A/30mA, DC-protection included
Overload protection built-in. Short cir-
cuit protection of C16A shall be mount-
ed on supplying network.
Not supported
Protective ground conductor must be
connected for the HALO to function
properly.