Chauvet LX-15 User manual

LX-15
User Manual

CHAUVET®, 2010, All Rights Reserved
Information and specifications in this User Manual are subject to change without notice. CHAUVET® assumes no
responsibility or liability for any errors or inaccuracies that may appear in this manual.
Author: Anthony Chiappone
Revision: 01a
Release Date: 12-27-2010
TABLE OF CONTENTS
1. BEFORE YOU BEGIN............................................................................................................................................................3
WHAT IS INCLUDED ......................................................................................................................................................................3
UNPACKING INSTRUCTIONS ...........................................................................................................................................................3
MANUAL CONVENTIONS................................................................................................................................................................3
ICONS........................................................................................................................................................................................3
SAFETY INSTRUCTIONS.................................................................................................................................................................4
2. INTRODUCTION.....................................................................................................................................................................5
PRODUCT OVERVIEW ...................................................................................................................................................................5
3. SETUP.....................................................................................................................................................................................6
ACPOWER.................................................................................................................................................................................6
MOUNTING .................................................................................................................................................................................7
Orientation...................................................................................................................................................................................................7
Rigging........................................................................................................................................................................................................7
4. OPERATING INSTRUCTIONS ..............................................................................................................................................8
\Standalone (Sound-Active)..........................................................................................................................................................................8
5. APPENDIX ..............................................................................................................................................................................9
GENERAL TROUBLESHOOTING .......................................................................................................................................................9
GENERAL MAINTENANCE.............................................................................................................................................................10
RETURNS PROCEDURE...............................................................................................................................................................10
CLAIMS ....................................................................................................................................................................................10
TECHNICAL SPECIFICATIONS..............................................................................................................................................11
CONTACT US...........................................................................................................................................................................12

1. Before You Begin 3 1/11/2011 6:12 PM
1.BEFORE YOU BEGIN
What is included
•1 x LX-15
•1 x Power Cord
•1 x Warranty Card
•1 x User Manual
Unpacking Instructions
Immediately upon receiving a fixture, carefully unpack the carton, check the contents to
ensure that all parts are present, and have been received in good condition. Notify the
shipper immediately and retain packing material for inspection if any parts appear damaged
from shipping or the carton itself shows signs of mishandling. Save the carton and all packing
materials. In the event that a fixture must be returned to the factory, it is important that the
fixture be returned in the original factory box and packing.
Manual Conventions
CHAUVET® manuals use the following conventions to differentiate certain types of
information from the regular text.
CONVENTION MEANING
[10] A DIP switch to be configured
<Menu> A key to be pressed on the fixture’s control panel
1~512 A range of values
50/60 A set of values of which only one can be chosen
Settings A menu option not to be modified (for example, showing the operating
mode/current status)
MENU >
Settings A sequence of menu options to be followed
ON A value to be entered or selected
Icons
This manual uses the following icons to indicate information that requires special attention on
the part of the user.
ICONS MEANING
This paragraph contains critical installation, configuration or operation
information. Failure to comply with this information may render the
fixture partially or completely inoperative, cause damage to the fixture
or cause harm to the user.
This paragraph contains important installation or configuration
information. Failure to comply with this information may prevent the
fixture from functioning correctly.
This paragraph reminds you of useful, although not critical, information.

1. Before You Begin 4 1/11/2011 6:12 PM
Safety Instructions
•Please keep this User Manual for future consultation. If you sell the unit to another
user, be sure that they also receive this instruction booklet.
•Always make sure that you are connecting to the proper voltage, and that the line
voltage you are connecting to is not higher than that stated on the decal or rear panel
of the fixture.
•This product is intended for indoor use only! To prevent risk of fire or shock, do not
expose fixture to rain or moisture.
•Make sure there are no flammable materials close to the unit while operating.
•The unit must be installed in a location with adequate ventilation, at least 20 in (50
cm) from adjacent surfaces. Be sure that no ventilation slots are blocked.
•Always disconnect from power source before servicing or replacing fuse and be sure
to replace with same fuse source.
•Secure fixture to fastening device using a safety chain.
•Maximum ambient temperature (Ta) is 104° F (40° C). Do not operate fixture at
temperatures higher than this.
•In the event of a serious operating problem, stop using the unit immediately. Never try
to repair the unit by yourself. Repairs carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest authorized technical assistance
center.
•Never connect the device to a dimmer pack.
•Make sure the power cord is never crimped or damaged.
•Never disconnect the power cord by pulling or tugging on the cord.
•Never carry the fixture directly from the cord. Always use the hanging/mounting
bracket.
•Avoid direct eye exposure to the light source while it is on.
Please read these instructions carefully. It includes important information
about the installation, usage, and maintenance of this product.

2. Introduction 5 1/11/2011 6:12 PM
2.INTRODUCTION
Product Overview
Safety
Fuse holder
Power In
Microphone
Microphone Sensitivity
Back Panel

3. Setup 6 1/11/2011 6:12 PM
3.SETUP
AC Power
This fixture runs on 100~240 VAC, 50/60 Hz. Before powering on the unit, make sure the line
voltage to which you are connecting it is within the range of accepted voltages.
To determine the power requirements for a particular fixture, see the label affixed to the back
plate of the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating
indicates its average current draw under normal conditions.
Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only
as a 0 to 100% switch.
Always connect the fixture to a circuit with a suitable electrical ground.

3. Setup 7 1/11/2011 6:12 PM
Mounting
Orientation
The LX-15may be mounted in any position, provided there is adequate room for ventilation.
Rigging
Be sure that the structure can support the weight of the fixture. Please see the “Technical
Specifications” section of this manual for a detailed weight listing. Mount the fixture securely.
This may be done with a screw, nut and bolt, or a hanging clamp. The hole in each bracket is 13
mm in size. When rigging consider routine maintenance and access. Please see the following
notes on installation.
•When aiming the fixtures, you may use the bracket adjustment knob. Loosen the
knob, adjust to the desired angle, and then tighten the knob by turning clockwise. Do
not use tools for this step, as it may cause damage.
•Safety cables must always be used.
Mounting
bracket
Do not use a tool on
the bracket
adjustment knob

4. Operating Instructions 8 1/11/2011 6:12 PM
4.OPERATING INSTRUCTIONS
\
Standalone (Sound-Active)
Please see the instructions below for details on this mode.
1. Plug the fixture into power.
2. Rotate the microphone sensitivity adjustment knob until the desired level has been
reached.
The microphone will only respond to low frequencies (bass).

5. Appendix 9 1/11/2011 6:12 PM
5.APPENDIX
General Troubleshooting
S
YMPTOM
P
OSSIBLE
C
AUSE
(
S
)
P
OSSIBLE
A
CTION
(
S
)
Breaker/Fuse
keeps blowing
•Excessive circuit load •Check total load placed on the
electrical circuit.
•Short circuit along the power
wires •Check for a short in the electrical wiring (internal and/or external).
Device does not
power up
•No power •Check for power on Mains.
•Loose power cord •Check power cord
•Blown fuse •Replace fuse with same type &
rating
If you still have a problem after trying the above solutions, please contact CHAUVET®
Technical Support.

5. Appendix 10 1/11/2011 6:12 PM
General Maintenance
To maintain optimum performance and minimize wear, fixtures should be cleaned frequently.
Usage and environment are contributing factors in determining frequency. As a general rule,
fixtures should be cleaned at least twice a month. Dust build up reduces light output
performance and can cause overheating. This can lead to reduced lamp life and increased
mechanical wear. Be sure to power off fixture before conducting maintenance.
•Unplug fixture from power.
•Use a vacuum or air compressor and a soft brush to remove dust collected on
external vents.
•Clean all lenses when the fixture is cool with a mild solution of glass cleaner or
Isopropyl Alcohol and a soft lint free cotton cloth or lens tissue.
•Apply solution to the cloth or tissue and drag dirt and grime to the outside of the lens.
•Gently polish optical surfaces until they are free of haze and lint.
Always dry the parts carefully after cleaning them.
Never spin a fan using compressed air.
Returns Procedure
Returned merchandise must be sent prepaid and in the original packing; call tags will not be
issued. Package must be clearly labeled with a Return Merchandize Authorization Number (RMA
#). Products returned without the RMA # will be refused. Call CHAUVET® and request an RMA
# prior to shipping the fixture. Be prepared to provide the model number, serial number and a
brief description of the cause for the return. Be sure to pack fixture properly; any shipping
damage resulting from inadequate packaging is the customer’s responsibility. As a suggestion,
proper UPS packing or double-boxing is always a safe method to use. CHAUVET® reserves the
right to use its own discretion to repair or replace product(s).
If you are given an RMA #, please include the following information on a piece of paper
inside the box:
1) Your name
2) Your address
3) Your phone number
4) The RMA #
5) A brief description of the symptoms
Claims
Damage incurred in shipping is the responsibility of the shipper; therefore, the damage must be
reported to the carrier upon receipt of merchandise. It is the customer's responsibility to notify
and submit claims with the shipper in the event that a fixture is damaged due to shipping. Any
other claim for items such as missing component/part, damage not related to shipping, and
concealed damage, must be made within seven (7) days of receiving merchandise.

T
ECHNICAL
S
PECIFICATIONS
WEIGHT & DIMENSIONS
Length ................................................................................................................7.1 in (181 mm)
Width.....................................................................................................................7 in (177 mm)
Height.................................................................................................................6.2 in (157 mm)
Weight.................................................................................................................2.9 lbs (1.3 kg)
POWER
Auto-ranging power supply..................................................................100~240 VAC, 50/60 Hz
Power consumption @ 120 V.........................................................................12 W (0.1 A) max
Power consumption @ 230 V.........................................................................11 W (0.1 A) max
Fuse ........................................................................................................................F 1 A, 250 V
LIGHT SOURCE
Type ............................................................................high-power, tri-color, single source LED
Quantity.....................................................................................................................................1
Rating (RGB) ................................................................................3 W, 350 mA x 3, 50,000 hrs
PHOTO OPTIC
Coverage angle .....................................................................................................................36°
INDOOR/OUTDOOR
Rating...........................................................................................................For indoor use only
THERMAL
Maximum ambient temperature ..........................................................................104° F (40° C)
ORDERING INFORMATION
LX-15...................................................................................................................................LX15
WARRANTY INFORMATION
Warranty.................................................................................................1-year limited warranty

CONTACT US
WORLD WIDE
General Information .................................................................................................CHAUVET®
Address ........................................................................................................5200 NW 108th Ave
Sunrise, FL 33351
Voice......................................................................................................................954-929-1115
Voice (toll free)......................................................................................................800-762-1084
Fax.........................................................................................................................954-929-5560
Technical Support....................................................................................................CHAUVET®
Voice 954-929-1115 (Press 4)
Fax.........................................................................................954-929-5560 (Attention: Service)
Email......................................[e-mail]
World Wide Web .......................................................................http://www.chauvetlighting.com
UNITED KINGDOM & IRELAND
General Information ..............................................................................CHAUVET® Europe Ltd
Address ............................................................................................................................Unit 1C
Brookhill Road Industrial Estate
Pinxton, Nottingham, UK
NG16 6NT
Voice............................................................................................................+44 (0)1773 511115
Fax...............................................................................................................+44 (0)1773 511110
EMail....................................[e-mail]
World Wide Web .....................................................................http://www.chauvetlighting.co.uk