Classic Exhibits visionary MOD-1294 User manual

© 2018
Order #XXXXX
*
Infill
Door
Door
Infill
Infill
Infill
Infill
Infill
1
1
2
3
4
4
5
6
Completed Assembly
Item
1
2
3
4,4A
5,5A
6,6A
Qty.
2
1
1
2,2
1,1
1,1
Description
38” Vertical Extrusion
38” Vertical Extrusion w/ Door Stop
38” Vertical Extrusion w/ S44
18” Z45 Horizontal Extrusion
34.44” Z45 Curved Horizontal Extrusion
24.5085” Z45 Curved Horizontal Extrusion
Steps:
1) Connect horizontals [4] [5] [6] & [6A] between verticals [1] [2] & [3].
2) Place infills on top of horizontals [4] [5] & [6] then secure with horizontals
[4A] [5A] & [6A]. Note: Velcro must face inside of assembled counter.
3) Connect door to vertical [3]. See Door Connection detail.
4) Connect shelf supports to Velcro on infills.
5) Place shelf on top of supports.
6) Place counter top on top of horizontals [4A] & [5A]. See Counter Top Lock detail.
7) Attach power cords for USB Port charging assembly.
Counter Top
Shelf
Shelf Support
*
*
Door
Hinge
Hinge
Pin
Slide pin into
hinge attached
to vertical.
Slide door
hinge over pin.
Door Connection
*
4A
4A
5A
6A
Align hole with pin Rotate pin. Spring
will push pin into hole.
Counter Top Lock
12
*
Pin
Hole
*
SETUP INSTRUCTIONS
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
MOD-1294 Counter

© 2018
Order #XXXXX General Information
DO NOT USE POWER TOOLS
ALL CONNECTIONS MUST
BE TIGHTLY SECURED
Part Identification - Numbering
Spline Connection Base Plate & Extrusion Connection
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup instructions are laid out sequentially in
steps, including exploded views with detailed
explanation for assembly.
WARNING
Cleaning & Packing
- For Cleaning Metal, Plex, & Laminate Parts:
Use a MILD NON-ABRASIVE cleanser and
soft cloth/paper towel to clean all surfaces.
- Keep exhibit components away from heat
and prolonged sun exposure.
Heat and UV exposure will warp and
fade components.
- Retain all provided Packing Materials.
All provided packing materials are for
ease of repacking & component protection.
Disassembly
- For loss prevention, tighten all setscrews
and locks during disassembly
7A
Hex Tool - Essential for Assembly
Extrusion & Lock Connection Engaged Lock
LADDERS OR LIFTS
MAY BE REQUIRED