Classic Exhibits VISIONARY DESIGNS MOD-1549 Manual

© 2019
Order #XXXXX
Locked layer contains
placeholder marks.
Completed Assembly
Item
1,1A
2
3,3A
4,4A
5,5A
--
--
Qty.
1,1
2
1,1
1,1
1,1
1
1
Description
43.614” GS300 Vertical Extrusion w/ PR53
11.417” Z45 Horizontal Extrusion
40.578” Z45 Curved Vertical Extrusion
4.893” Z45 Horizontal Extrusion w/ V4
11.514” Z45 Horizontal Extrusion
Base
Podium Top w/ S10, PR37, & (2) Z46
Steps:
1) Attach assemblies [3/4/5] and [3A/4A/5A] to assembly [1/1A/2/2].
2) Connect Sintra panels to Velcro on sides of assemblies [3/4/5] and [3A/4A/5A].
3) Attach [3] [3A] to base, using M8 bolt into PR53 and [4] [4A] to base, using
5/16” bolts into V4 connectors.
4) Place shelf onto lips of [5] and [5A]. See Extrusion Lip detail.
5) Attach podium top between [1] [3] and [1A] [3A].
6) Attach wings to clamps on [1] and [1A]. See A10 Clamp detail.
5A
3A
Podium Top
Base
Wing Wing
M8
5/16” 5/16”
M8
Shelf
Sintra
Panel
Sintra
Panel
Infill
2
3
1
2
4A
1A
BACK VIEW FRONT VIEWFRONT VIEW
Keep V4 connectors permanently attached to [4] and [4A].
Keep PR53 permanently attached to [1] and [1A] and
attach M8 bolts, when packing.
Keep extrusions [1] [1A] with clamps and [2] assembled,
when packing.
Keep extrusions [3,4,5] and [3A,4A,5A] assembled,
when packing.
5
4
Extrusion [5] and [5A] have
lip for the shelf to rest upon.
Lip
Extrusion Lip
Tighten set screw to
secure A10 to extrusion.
A10 Clamp
Tighten knob to secure
wing panels.
MOD-1549 Podium
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
SETUP INSTRUCTIONS

© 2019
Order #XXXXX
DO NOT USE POWER TOOLS
ALL CONNECTIONS MUST
BE TIGHTLY SECURED
Part Identification - Numbering
Spline Connection Base Plate & Extrusion Connection
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup instructions are laid out sequentially in
steps, including exploded views with detailed
explanation for assembly.
WARNING
Cleaning & Packing
- For Cleaning Metal, Plex, & Laminate Parts:
Use a MILD NON-ABRASIVE cleanser and
soft cloth/paper towel to clean all surfaces.
- Keep exhibit components away from heat
and prolonged sun exposure.
Heat and UV exposure will warp and
fade components.
- Retain all provided Packing Materials.
All provided packing materials are for
ease of repacking & component protection.
Disassembly
- For loss prevention, tighten all set screws
and locks during disassembly.
7A
Hex Tool - Essential for Assembly
Extrusion & Lock Connection Engaged Lock
LADDERS OR LIFTS
MAY BE REQUIRED
General Information