Clear One COLLABORATE Live 900 User manual

COLLABORATE®Live 900
Quick-Start Guide

COLLABORATE LIVE 900
2
COMPONENTS INCLUDED
COLLABORATE Live 900
COLLABORATE Live
codec with power supply,
COLLABORATE Remote
control with dongle, and
HDMI cable.
910-2100-003
UNITE 200 PTZ camera,
power supply, HDMI cable
and RS232 Serial Control
cable.
Note: The remote control
inside the camera box
is only for any advanced
configuration in the camera,
if required.
For the camera’s control, use
the COLLABORATE Codec
Appliance’s remote control.
CONVERGE Pro 2 48V
Mixer, Beamforming
Microphone Array 2,
cables and power
supplies.
Note: The Beamforming
Microphone Array 2
mounting kit must be ordered
separately.

QUICK-START GUIDE
3
MAKING THE CONNECTIONS
Connect the Beamforming Microphone Array 2 to the CONVERGE Pro 2 48V.
Then, connect the CONVERGE Pro 2 48V, UNITE 200 camera, Ethernet, and
monitor(s) to the COLLABORATE Live codec as shown.
NOTE: Audio output and power connections not shown.
Ethernet Connection
CONVERGE Pro 2 48V
1080p HDMI Camera Video
USB Audio Transmit and Receive
HDMI
Output
Display Port
Output
UNITE
Camera
Camera Serial Control
E-bus From LINK Out
Beamforming Microphone
Array 2
Loud Speakers
Amplifier
Amplifier

COLLABORATE LIVE 900
4
CONNECTING THE REMOTE CONTROL DONGLE
The Remote Control includes a dongle that plugs into the FRONT USB
port on the codec.

QUICK-START GUIDE
5
CONFIGURING DISPLAY SETTINGS
After all peripherals are connected to the unit, turn the unit on.
Once COLLABORATE Live is loaded – you will see your local camera
video on your screen.
Using the remote control, navigate to the display settings:
Settings > Advanced > Display
According to your monitor capabilities, set to the maximum supported
resolution. If 2 monitors are connected to the unit, the display mode is
automatically changed to dual mode and you can set both monitors’
resolutions.