Click Medical QuickFit Lacer User manual

Compatible with:
QuickFit™ Lacer Lg OK0240-230-05
QuickFit™ Lg Releasing Lacer OK0165-230
Pull dial open to release tension.
Locate two removal portals on
lower reel.
Snip lace to remove old dial and lace from the
system.
Use patient to fill device. Feed new lace through
all guides.
Fully insert flat-head
screwdriver into one of the
two ports. Use tool to pry
reel upward untill cartridge
pops out of bayonet.
Repeat on opposite port,
releasing reel fully.
1x Replacement Lace, 2.0m 1x Replacement BOA®Reel
POP!
POP!
Click Medical, LLC
1205 Hilltop Parkway, W101
Steamboat Springs, CO, 80487
USA
[phone]
EC REP
MDSS GmbH
Schiffgraben 41
30175 Hannover,
Germany
6
W
A
R
R
A
N
T
Y
MONTHS
2
WARRANTY:
www.clickmedical.co/terms/#warranty
U.S. Customers:
Contact Click Medical directly
[email protected]
Help Line: [phone]
International Customers:
Please contact your local distributor
6 14458 81682 5
Must be installed by a trained professional.
Lace will wear. At minimum, inspect monthly.
Overtightening could reduce circulation.
Do not use on patients with nerve issues.
Keep lace away from sharp edges.
Advisory
Kit Contents:
1 2
3
For help and video instructions:
clickmedical.co/quickfit-lacer
Replacement Reel Kit Size: Lg
RP0200-230-05
Revised 2019
Lace Locks
See advisories in other languages: clickmedical.co/advisories
4

CLICK!
POP!
Lace is above
flange
Lace is below
flange
CLICK!
CLICK!
Correct lacing
Incorrect lacing
Ensure lace is fed through each guide. Pull the lace until
tight and measure 10-25cm from the upper guide to the
end of the lace. Add 3cm to each lace and cut.
Hold lace lock with pliers. Push lace
through back of hole, then loop
lace around backside and through
the second hole. Lace tail should
be 2.5mm-5.0mm.
Press down on new reel to ensure it is closed. Turn the
dial until the two arrows align.
Pull lace tight to set. Flex lace lock back and forth to break off connector. Pull
lace firmly into reel. Repeat for opposite lace.
To assure lace is correctly inserted, feed lace through top exit port and pull through bottom reel window.
Repeat for opposite side lace.
Insert reel into base by aligning the notch with the #1 on the
mouning plate and pushing into place. Then turn reel counter
clockwise. The #2 will then be visible.
Pull outward on dial to ensure proper installation
then cycle system to test for smooth function:
Push to engage.
Twist to tighten.
Pull to release.
3cm
2.5mm-5.0mm
10-25cm
Note: Lace locks and tail should not be visible when lace is seated properly.
Note: If system feels
rough, remove reel
(see steps 1-2) and
check that knot and
tail are seated
properly (see step 9).
56
7
8 9
10 11