
Connect Cables, Wired BeltPacks
and Headsets
• ConnectWiredBeltPack(Cat-5)cablingtodesired
channelsonfrontofWiredInterface
(A/BorC/D)
• ConnectoppositeendofWiredBeltPackcablingto
eachWiredBeltPack
• PlugaheadsetintoeachWiredBeltPack
• TurnONWiredBeltPacksandconrmpower
Test Wired BeltPack Communication
(requires 2 people)
• PutonheadsetandpressTalk(T)buttonontheWired
BeltPackandconrmyoucancommunicatewitha
secondWiredBeltPackonbothchannelswithno
crosstalk
• RepeattestforeachWiredBeltPackandHeadset
combination
Set Up Wireless Beltpacks (on sideline)
• UnpackheadsetsandWirelessBeltPacksandlaythem
outacrossbenchortable
• Ifneeded,replacebatterieswithfullycharged
batteries
• ConnectheadsettoeachWirelessBeltPack
• PowerONtheBeltPacks(seegure)andconrm
thateachunitlogsintoitsrespectiveBaseStation
Walk Test Wireless BeltPacks
(requires 2 people)
• PutonheadsetandWirelessBeltPackcombination
• PressTalkbuttonfortheactivechannelonthetopof
theWirelessBeltPack.Conrmyoucancommunicate
withasecondWirelessBeltPackonthesamechannel
(A,B,CorD).Note: available channels will be based
on your system’s configuration. If your system only
operates on A/B, then C/D will likely be disabled
• IMPORTANT!Eachtestershouldwalktheir
WirelessBeltPacktooppositegoallinesandback
ensuringclearcommunicationwiththeother
tester.AlwaysplaceWirelessBeltPackonhip
oppositefromthepressboxwhenwalktesting
• RepeatwalktestforeachWirelessBeltPack
2 sec
POWER ON
3
4
5
6
FormoreinformationonsettinguptheTempestFXsystem
refertotheTempestFXUserManualorcontactourTechnical
Supportat1.800.749.2761.
© 2013 CoachComm LLC. All rights reserved. Tempest®is a registered trademark of CoachComm, LLC D0000049 Rev C, Aug 2013