Coltene CanalPro Jeni User manual

CanalProTM Jeni
Step by Step

Connect the basic unit to the power supply
( ). Check whether the SD card is placed in
the SD card slot ( ) in the back of the basic
unit.
Connect the motor with the display
station (➔).
Connect the contra-angle (ISO E-connection) with the motor (must not be rotated).
Assemble the apex locator set (a, b, c, d, e) and insert it into the basic unit ( ).
CanalProTM Jeni Assembly Guide
6
Switch on the basic unit (On/Off button ➔).
1
Set the foot switch on the floor within
working distance of the basic unit.
46
ac
d e
b
2
3a
3b
Apex locator cable set consisting of:
a) Measuring cable with plug
b) Lip clip
c) Cap for socket (for hygienic use of lip clip)
d) Cable for file clamp (if applicable)
e) File clamp (if applicable)
5

CanalProTM Jeni First Steps (1/2)
Press here for your
language setting and
to adjust the volume
of the signal sounds.
Set the desired working
length by touching the
respective bar in the
depicted canal.
Press here to turn off
the apex locator.
In the file system setup,
you can choose the
files to be displayed
per sequence.
For using only the apex locator press the "Apex" button.
For preparation, press the "Preparation" button.
Press the "Preparation" button and choose your desired file
set. You can also customize your own file set in the "Doctor’s
choice" mode.
Set your individual settings for sounds, volume and apex
stop here.
7
9
8
10
a
e
c
d
b
b
b
b
b
a
c
d
b
Press here to calibrate the motor. The motor
should be calibrated after each change of the
contra-angle.
Also press here to adjust the apex
settings (volume, tone, apex stop).
e

CanalProTM Jeni First Steps (2/2)
Press here to switch off
the apex locator.
The CanalPro™ Jeni continuously adapts to the individual root canal anatomy and constantly regulates
rotary movement, torque and file stress.
Move the root canal file steadily forward under light pressure, no pecking required. Maintain pressure
until a long acoustic sound indicates that the canal needs to be irrigated. Remove the file from the canal
and irrigate the canal. Then proceed with the preparation as described above. Many short acoustic sounds
signal a necessary file change.
Start the motor by pressing down the foot switch.Select the required file and adjust the lip clip before starting root canal treatment.
11
13
12
f
f
80000095 06.20