Commend GE 300 User manual

GE 300
MANUAL VERSION 3.3/0518
PRODUCT MANUAL
ENGLISH

GE 300
23.3/0518
Manufacturer's Reference:
Disposal and recycling
Legal Notice:
The manufacturer guarantees the functionality of its products as described in the data sheets and / or tech-
nical documentation. For error-free operation of the Intercom system, faultless transmission paths are
mandatory. The functionality of transmission paths, in particular of IP-networks, exclusively is the respon-
sibility of the operating company of the transmission path and therefore the manufacturer can not be re-
sponsible in any manner, for errors and problems, which result from problems or malfunctioning of the
transmission path.
Warning:
This is a Class A product (standard EN 55032:2015). In a domestic environment this product may cause
radio interference in which case the user may be required to take adequate measures.
Defective power cables of the transformer shall not be repaired or changed. In case of defective power
cables, the transformer (of the GEZ 300) must be exchanged.
Mounting and installation of the Intercom Server and of the equipment may be
carried out by authorised service personnel only.
Cards may be exchanged only while the voltage is switched off.
Always make sure ESD precautions have been taken before exchanging cards. The M3 screw nut
of the motherboard G3-GEM (see page 13) is used as grounding point for Wrist Strap Grounding.
GE 300
Version: 3.3/0518
Number of pages: 38
This device complies with the European directives listed below by fulfilling corresponding
standards:
Electromagnetic compatibility (directive 2014/30/EU)
Electrical equipment designed for use within certain voltage limits (directive 2014/35/EU)1)
The restriction of the use of certain hazardous substances in electrical and electronic equip-
ment (directive 2011/65/EU)
1) Only with included power supply
Equipment with this symbol shall not be disposed of together with household or
commercial waste.
The directive 2012/19/EU on waste electrical and electronical equipment (WEEE) is
applicable in the European Union member states.

GE 300
3.3/0518 3
Content
General information 4
PDF format 4
Info boxes 4
Legend of requirements 4
Quick start 5
1. GE 300 variants 6
Available product variants 6
Additional housing 8
2. Additional components 9
General 9
3. Assembly of components 10
Remove housing cover 10
Plug-in positions of the cards 11
Connection of interface housing GEI 300 12
4. Cabling 13
Mounting, cable run 13
GE 300 mounting with protection against contact 14
Connection diagram 15
Connection to the network 16
Connection subscriber cards 16
Connection of input/output cards 17
5. Configuration CCT 800 19
Configuration via IP or RS-232 19
Start-up of a networked system 20
Configuration power management 23
General information 24
Expansion 24
Line length subscribers 24
Standard call numbers 25
Maximum number of conversations 26
Technical data 28
Intercom Server GE 300 / GE 300WR 28
Expansion housing GEZ 300 28
Interface housing GEI 300 29
LED-status indication 30
Motherboard G3-GEM 30
IP-network card G3-LAN 31
VoIP card G3-IAX 32
Subscriber cards 33
Input/output cards 34
Interface cards 36
Technical Support 38

General information GE 300
43.3/0518
General information
PDF format
Supported viewers
The PDF manual can be used with the following viewers:
Adobe Reader from version 6.0
Foxit Reader from version 5.0
Info boxes
Legend of requirements
In the left-hand margin, requirements for the respective features are displayed as follows:
ATTENTION
This information box addresses all necessary configuration options and actions which will allow an
error-free operation. Also, this box will warn you if a certain configuration, option or entered value
could lead to a malfunction of the application or a loss of data.
NOTE
This information box serves multiple purposes: It ranges from basic configuration tips to additional
advices and comments on occasional settings and events.
GOOD TO KNOW
This information box provides background knowledge which helps understand the basic principles
behind different configurations and the application itself.
Symbol Requirement
yRequired firmware version for the Intercom Server GE 300.

GE 300 Quick start
3.3/0518 5
Quick start
Intercom Server GE 300
The Intercom Server GE 300/GE 300WR has been designed to meet the internal communication de-
mands of small and middle sized companies and organisations. Different functions of modern internal
communication such as Intercom, information and control can be integrated into a single system. By
means of subscriber cards with different feature levels and additional interfaces the Intercom Server
can be adapted to the individual needs with ease.
This manual describes mounting of the hardware and start-up of the Intercom Server, subscriber cards
and input/output cards. Information about the interface cards and Intercom terminals can be found in
the respective manuals of the products. The following steps are required for start-up:
Start-up steps for the GE 300
Overview
This manual is split into following chapters:
1. GE 300 variants
2. Additional components
3. Assembly of components
4. Cabling
5. Configuration CCT 800
Installation of plug-in cards
Connection of
IntercomTerminals
Activation of
Licences
Configuration of:
- Features
- IP-Terminals
- Networks
Connection of
additional Servers
(only in networked systems)
Configuration of Server-IDs
and IP addresses
(only in networked systems)

1. GE 300 variants GE 300
63.3/0518
1. GE 300 variants
The GE 300 is available in different versions, which mainly differ in their extent of supply.
All variants of the GE 300 include the following functions:
Intercom Server with five plug-in slots
Up to 40 subscribers
One AF input (for music or alarm)
Two inputs for floating contacts
Two relay outputs
Configuration via Ethernet or RS-232
The following section introduces the respective features and benefits of the available variants of the
GE 300.
Available product variants
Intercom Server GE 300 (incl. 30 W power supply unit)
Illustration of GE 300 including 30 W power supply unit
GE 300EU (incl. 30 W power supply unit with Europlug – „PA30W24V-EU“).
GE 300CA (incl. 30 W power supply unit with US/UK/AUS adapter – „PA30W24V-CA“).

GE 300 1. GE 300 variants
3.3/0518 7
GE 300 without power supply unit
Illustration of GE 300 without power supply unit
Delivery without power supply unit.
Free choice of power supply unit possible (e.g. „PA60W24V“).
GE 300WR
Illustration of GE 300WR
Delivery without power supply unit
DC-UPS applications
Wide range input (20 – 36 VDC)
NOTES: Power supply of the subscribers
For an overview of the max. number of digital subscribers see page 8.
Intelligent power management (see page 23) handles the volume of the terminals and protects
against overload.

1. GE 300 variants GE 300
83.3/0518
Overview max. number of digital subscribers
Example: If an Intercom Server GE 300 is operated with an 60 W power supply unit, it is possible to
supply max. 36 subscribers via the Intercom Server using an Intercom Server with an expansion hous-
ing.
Additional housing
Expansion housing GEZ 300
Expansion housing including power supply with five plug-in slots
Intercom Server GE 300 required
Up to 80 subscribers together with Intercom Server GE 300
The following types are available:
Interface housing GEI 300
Interface housing with two slots for G8 interface cards.
Intercom Server GE 300 required.
Power supply via GE 300 or GEZ 300.
Max. number of digital subscribers with power supply via Intercom Server
Power supply 1) Intercom Server
(GE 300/GE 300WR)
Intercom Server +
expansion housing
(GEZ 300)
Intercom Server +
interface housing
(GEI 300)
Intercom Server +
expansion +
interface housing
(GEZ 300 and GEI 300)
GE 300 30 W 16 16 + 16 12 16 + 12
GE 300 60 W / 70 W 20 20 + 16 20 20 + 12
GE 300WR 30 W 16 16 + 16 12 16 + 12
1) Power supply refers to Intercom Server. Appropriate configuration in CCT 800 is required (see page 23).
NOTES: Operating more digital subscribers
If more digital subscribers are needed, the following options are available:
Using external power supply for digital stations (max. 20 digital subscribers per housing can be
operated).
Using an Intercom Server GE 800.
Type Power supply
GEZ 300EU Transformer 230 V Europe
GEZ 300AU Transformer 230 V Australia
GEZ 300US Transformer 240 V UK
GEZ 300UK Transformer 120 V USA
NOTES: Power supply GEZ 300
The extent of supply of the expansion housing GEZ 300 includes a transformer. Therefore, its power sup-
ply is independent of the Intercom Server. For more information about the power supply see ”Connection
diagram” on page 15.

GE 300 2. Additional components
3.3/0518 9
2. Additional components
General
In addition to the Intercom Server, for start up of the system the following components are required:
Subscriber cards: Subscriber cards handle the speech communication as well as subscriber
specific functions. For connection of IP-based, digital and analogue subscribers, various cards are
available in four feature levels (B, C, D and P). The cards of the higher levels contain all features of
the lower ones plus additional features. With feature level P, individual feature levels can be advised
to each subscriber.
VoIP cards: Due to the support of wide spread standards such as the SIP or IAX protocol, various
VoIP telephones or entire VoIP telephone systems can be connected to the Intercom system as sub-
scribers with VoIP cards.
Input and output cards: Input and output cards are used for the reading in of floating contacts and/
or operating of controls such as door openers or barriers via floating relay contacts (depending on
type).
Interface cards: By means of interface cards, external systems such as telephones, PCs or mobile
radios can be connected and integrated.
Connection and networking cards: Via connection and networking cards, it is possible to con-
nect the Intercom Server to LAN/WAN (TCP/IP), 2-wire lines, ISDN, multiplexer/media converter or
the public telephone network. Connection: restricted features. Networking: full range of features –
Intercom Servers operate as if they were in one location.
Installation boards: Installation boards help to connect plug-in cards e.g. with Intercom stations,
interfaces, inputs or outputs.
Licences: With licences the functionality of the Intercom Server and the plug-in cards can be ex-
panded.
NOTE: Additional components
These components must be ordered separately according to customer requirements.
For technical data of the Intercom Server cards, see current datasheet of the desired card.
Before beginning with assembly, make sure all required components are at hand.
For information about the configuration, see the respective manual or manual “Intercom Server
Configuration”.

3. Assembly of components GE 300
10 3.3/0518
3. Assembly of components
Remove housing cover
Remove the housing cover
ATTENTION: Exchanging cards
Exchanging the cards may only be carried out while the power is switched off!
NOTE: Remove screws
In case a protection against contact has been fixed with screws (see page 14), these screws have to be
removed before lifting the cover.
GE 300
Attention
OBSERVE PRECAUTIONSFOR HANDLING
OF ELECTROSTATIC SENSITIVE DEVICES!
Achtung: Darf nur durch geschultes Personal geöffnet werden #VVGPVKG/CICNNGGPIGQRGPFYQTFGPFQQTIGMYCNKƂEGGTFRGTUQPGGN
#VVGPVKQP/C[QPN[DGQRGPGFD[SWCNKƂGFRGTUQPU Attenzione: Darf nur durch geschultes Personalgeöffnet werden
Attention: Seul ie personnel qualife est autorise a l ouvrir! Atencion: Darf nur durch geschultes Personal geöffnet werden
Press here to remove the housing cover