CommScope BUDI-2S-SP User manual

1. General
BUDI is a building distributor with a fiber management system offering
splicing functionality. It provides mechanical and environmental
protection for fiber optic components.
2. Kit content
BUDI-2S-SP
INSTALLATION INSTRUCTION
3. Feeder cable installation
3.3 Cut the rubber seal where the feeder cable will be installed.
3.4 Break off the parts needed for feeder cable termination.
3.2 Strip the loose tube 2cm after the outer jacket.
3.1 Strip the feeder cable (1.5m) and leave some aramid yarn for
termination.
TC-1088-IP
Rev A, Mar 2017
www.commscope.com

2
3.6 Install the insert into the cable holder, depending the cable
diameter.
3.7 Install the feeder cable into the holder.
3.8 Route the aramid yarn around the lips as shown on the pictures
for termination.
3.5 Break off the parts needed for feeder cable termination.
ø 7 - 9,5 ø 5,5 - 7 ø 4 - 5,5 Cover

3
3.10 Close the cable holder with the cover. Check the orientation of
the arrow on the cover.
3.11 Install the cable holder into the box on the lowest position
(adjust the position depending on the cable diameter)..
3.12 Route the fibers of the feeder cable towards the splicing trays.
3.9 Route the aramid yarn along the feeder cable.

4
4. Drop cable installation
4.1 Slide the termination device over the drop cable.
4.4 Cut the rubber seal where the drop cable will be installed.
4.2 Strip the drop cable over a length of 1,5 m and route the
aramid yarn into the slit of the device.
4.3 Install the holder for the termination device into the box. Check
the orientation of the device.
4.5 Install the drop cable into the seal and pull the termination
device back into the holder.

5
4.6 Cut the aramid yarn and close the holder with the cover. 4.7 Route the fibers of the drop cable towards the splicing tray.

6
5. Closing the box
5.1 Install the cover on the box and close with the screw.

7

© 2017 CommScope, Inc. All rights reserved.
All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc.
This document is for planning purposes only and is not intended to modify or supplement any specifications or warranties relating to
CommScope products or services.
This product is covered by one or more U.S. patents or their foreign equivalents. For patents, see:
www.commscope.com/ProductPatent/ProductPatent.aspx.
To find out more about CommScope® products, visit us on the
web at www.commscope.com
For technical assistance, customer service, or to report any
missing/damaged parts, visit us at:
http://www.commscope.com/SupportCenter