CommScope FTUO User manual

FTUO
INSTALLATION INSTRUCTION
Fiber termination Unit-Outdoor
• Box
• Tie-wraps
• Hook and loop fastener
• Silicone tube
• Rubber seal
• SMOUV/ANT inserts
For loose accessories see datasheet.
1 Kit content
2 Marking/drilling
Remove the tray before drilling the holes.
3.2 Mark and cut the transportation tube (not included) to length as
shown. Slide the silicone tube 20 mm over the tube.
3.3 Feed the pigtail through the transportation tube into the FTUO.
Required length ± 1.5 m.
3 Termination of the customer connection,
pigtail
3.1 Feed the transportation tube (max. ø 5 mm) through the rubber
seal into the FTUO. Secure the FTUO against the wall.
2.1 1 Wall securing positions
2 Through the wall applications ø 5 mm (knock-out)
3 On the wall applications ø 5 mm (drill ø 10 mm holes)
4 Feeder cable entry ports max. ø 12 mm (cut out by
using pliers)
5 Optional CommScope splitter location
3.4 Secure and seal the rubber with the tube and pigtail onto the
box with tie-wraps.
1 1
5
3
3
3
4
4
3
2
2
TC-913-IP
Rev A, Mar 2017
www.commscope.com

4 Installation of the feeder cable
4.1 Feed the 12/8 tube or cable through the rubber seal. Secure
the tube with hook and loop fastener and tie-wraps as shown. Feed/
blow the feeder cable through the tube. Remove the outer jacket at 50
mm from the tube end. Required fiber length inside the box is ± 1.5 m.
5 Splicing and routing
5.1 1 Route the pigtail to the securing position and remove the
outer jacket. Leave 20 mm of aramid yarn to secure with
hook and loop fastener and tie-wrap.
2 Entering the box from the side with customer cable.
Follow the routing in case of entering from the left side.
3 Feeder cable for in-line applications.
1
2
23
2
2
5.2 Splice the fibers, install the RECORDsplice or SMOUV/ANT into
the splice holder. Insert included in the kit for SMOUV/ANT.
5.3 Install the cover onto the box with the screw. Possibility to install a
security label onto the screw.
© 2017 CommScope, Inc. All rights reserved.
RECORDsplice, SMOUV and all trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of
CommScope, Inc.
This document is for planning purposes only and is not intended to modify or supplement any specifications or warranties relating to
CommScope products or services.
This product is covered by one ore more U.S. patents or their foreign equivalents. For patents, see:
www.commscope.com/ProductPatent/ProductPatent.aspx.
To find out more about CommScope® products, visit us on the
web at www.commscope.com
For technical assistance, customer service, or to report any
missing/damaged parts, visit us at:
http://www.commscope.com/SupportCenter