“K” Style Lid Kit Installation Instructions
© 1998-2010, IMI Cornelius Inc. - 1 - Publication Number: 620910101
INSTALLATION INSTRUCTIONS
“K” STYLE LID KIT, P/N 629083501
REAR MOUNT
These “K” style kits apply to the following ice makers and are for use with DF/ED 200/250 dispensers:
Disconnect power to the unit before installing the adaptor following all lockout/tag out procedures established by the
user. Verify that all the power is off to the unit before performing any work.
Failure to comply could result in serious injury, death or damage to the equipment.
All ice baffle plates and bin stats, if included or recommended in this kit, must be installed as directed in this manual or
the equipment manufacturer’s instructions.
Failure to comply could result in serious injury, death or damage to the equipment.
All of the attachment screws and plates must be installed as directed in this manual.
Failure to comply could result in serious injury, death or damage to the equipment.
1. Set Ice maker lid on the top of the dispenser and position it flush with the back and sides of the dispenser.
2. Using the slotted holes in the lid as a template, drill four (4) 0.147” diameter holes at the bottom of the slots (see
detail A). Use extreme care not to drill into the hopper. Fasten the lid to the dispenser with four (4) #10 sheet
metal screws, two on each side.
3. Seal the ice maker to the top of the dispenser as follows:
A. Apply beads of RTV around the opening in the lid and inside the perimeter of the ice maker outline so
that the ice maker will set on the RTV.
B. Set the ice maker onto the lid and position it as required, front flush with rear of lid.
C. Wipe away any excess RTV.
4. Install Mounting Brackets (Item 2) by drilling 0.147” diameter holes into the adapter lid and ice maker cabinet
using brackets as templates. Use extreme caution not to drill into any ice maker components (condenser, tubing,
etc.). Secure the brackets using the screws provided.
5. Follow the ice maker manufacturers instruction to complete the installation of the ice maker including the bin ther-
mostat if so equipped or required.
Table 1. Applicable Models
Ice Maker Size
Manitowoc Q200/450/600/800 30”
Table 2. Loose Shipped Parts
Item No. Part No. Name Qty.
1 620024406 Lid Assembly, “K” Style 1
2 22127 Bracket, Mounting 2
3 50904 RTV, Clear, 732, 3 oz. Tube 1
4 620701601 #10 Sheet Metal Screw 12
5 620910101 Installation Instruction 1
Release Date: November 8, 2010 www.cornelius.com Revision: B
