Crestron Flex UC-MX70-U User manual

The UC-MX70-U Crestron Flex advanced tabletop conferencing system
provides a large room video conference solution for open-platform UC
applications. It supports a single video display and features a Crestron
Flex tabletop conference device, an HDMI® over CATx receiver, and an AI
collaboration camera.
In the Box
Tabletop Conference Device
1 Tabletop Conference Device (6510610)
1 Cable, CAT5e, RJ-45 - RJ-45, 12 ft (3.7 m) (2033988)
1 Cable Retention Plate (2047908)
1 Power supply (2045873) with cord (2042043)
3 Tie Wrap (2047935)
Additional Items
1 AI collaboration camera (6512296)
1 Microphone pod (6508084)
1 HDMI® over CATx receiver (6510312)
1 Cable, CAT6a, RJ-45 - RJ-45, 20 ft (6.1 m) (6507640)
1 Cable, thin HDMI®, 6 ft (1.8 m) (6510946)
1 Cable, HDMI, 6 ft (1.8 m) (6503565)
1 Cable, USB 2.0, A - Micro-B, 6 ft (1.8 m) (6510947)
1 IR Emitter Probe (6500940)
Install the Cable Retention Plate
The included cable retention plate provides tie-down points for cables
that connect to the Crestron® conference device.
Remove the adhesive backing from the cable retention plate and install
it on the underside of the conference device as shown in the following
diagram. Ensure the cable retention plate is firmly attached before
securing cables.
CAUTION: When turning over the device, place the device on a soft
surface to avoid damage.
NOTE: If a swivel mount kit (CCS-UCA-SMK) is to be used, use the
cable retention bracket included with the swivel mount kit as described
in the CCS-UCA-SMK DO Guide (Doc. 7882).
1
UC-MX70-U QuickStart
Crestron Flex Advanced Tabletop Large Room Video Conference System

UC-MX70-U QuickStart
Crestron Flex Advanced Tabletop Large Room Video Conference System
Connect
1. Make system connections as shown below.
2

2. Make the remaining system connections as shown below.
3
UC-MX70-U QuickStart
Crestron Flex Advanced Tabletop Large Room Video Conference System

Bundle Cables
Bundle the cables together and use a provided tie wrap to secure the
bundle to one of the positions on the cable retention plate at the rear of
the device. Avoid bundling power and data cables together.
Insert the included USB and HDMI cables into their respective cable
channels as labeled on the underside of the conference device and as
shown in the following image.
NOTES:
lWhen routing the USB and HDMI cables through the channels out
of the front of the device, the cables donot need to be bundled. If
the system design requires routing the USB and HDMI cables
through the rear of the device, the cables should be bundled and
secured to the cable retention plate.
lWhen using a swivel mount kit, do not route the USB and HDMI
cables through the swivel tube.
Configure
Configure the device using the web interface. To access the web
interface, enter the device's IP address into a web browser. Select the
gear icon in the upper right-hand corner of the screen and enter the
username ("admin") and password ("admin") when prompted.
NOTE: To find the device's IP address, tap the information icon on the
device's home screen.
For detailed configuration information, refer to the CCS-UC-1 Product
Manual (Doc. 7844).
Visit the Product Page
Scan the QR code to visit the product page.
UC-MX70-U
www.crestron.com/model/6511599
UC-MX70-U QuickStart
Crestron Flex Advanced Tabletop Large Room Video Conference System
4

Additional Information
Original Instructions
The U.S. English version of this document is the original instructions.
All other languages are a translation of the original instructions.
Crestron product development software is licensed to Crestron dealers and Crestron
Service Providers (CSPs) under a limited nonexclusive, nontransferable Software
Development Tools License Agreement. Crestron product operating system software is
licensed to Crestron dealers, CSPs, and end-users under a separate End-User License
Agreement. Both of these Agreements can be found on the Crestron website at
www.crestron.com/legal/software_license_agreement.
The product warranty can be found at www.crestron.com/warranty.
The specific patents that cover Crestron products are listed at
www.crestron.com/legal/patents.
Certain Crestron products contain open source software. For specific information, visit
www.crestron.com/opensource.
Crestron and the Crestron logo are either trademarks or registered trademarks of
Crestron Electronics, Inc. in the United States and/or other countries. HDMI is either a
trademark or registered trademark of HDMI Licensing LLC in the United States and/or
other countries. Other trademarks, registered trademarks, and trade names may be
used in this document to refer to either the entities claiming the marks and names or
their products. Crestron disclaims any proprietary interest in the marks and names of
others. Crestron is not responsible for errors in typography or photography.
©2021 Crestron Electronics, Inc.
Doc. 8806B
12/29/21
5
UC-MX70-U QuickStart
Crestron Flex Advanced Tabletop Large Room Video Conference System