Cyklos CFM 500 Quick start guide

1
PAPER FOLDING MACHINE CFM 500
OPERATIONAL MANUAL
1) Parameters
- folding speed 120 sheets/min.
-methods of folding standard letter, concertina, single
- sheet format A4, A5, A6
- basis weight 80 -120 g / m²
- input board capacity 200 sheets (80 g/m²)
-machine dimensions: working position - l = 295 mm,
w = 355 mm,
h = 365 mm
transport position -l = 295 mm
w = 355 mm
h = 280 mm
-machine weight 15 kg
- voltage / frequency 230 V / 50 Hz
-electric input 60 W
-electric current 300 mA
- fuse F 630 mA/250V
2) Machine description
WARNING:
a) The folder is designed only for folding paper specified in parameters.
b) It is forbidden to fold foils, sheets and similar materials.
c) The machine may be utilized only in a closed room (office, shop).
d) It is forbidden to utilize the machine outdoors.
e) It is forbidden to utilize the machine with damaged feeding cord.
f) It is forbidden to utilize the machine, if unusual sounds are heard.
INSTALLATION AND OPERATING INSTRUCTIONS
a) It is forbidden to operate the machine under a voltage different from the voltage
specified on the type label.
b) Prior to the machine utilization, definitely read all instructions.
c) To reduce the risk of injury, an inspection shall be essential, if the product
utilized in the vicinity of children.
d) It is forbidden to insert fingers or hands to the product after the feeding cord
connecting.
e) If the machine blocked, it shall be first necessary to disconnect the machine
from the mains supply, and then remove the cause of blocking.
f) It is forbidden to replace faulty fuse by another type, or by a fuse with different
power.

2
3) Working process
Tilt down the feeding board 4, hold it in the lower position and feed paper on it,
then push T-squares 8 towards the paper.
After pressing the „start button“ 1, paper is automatically fed from the pile and folded
into the waste box. It is necessary to remove paper from the waste box during
operation to prevent its overfilling. It is advisable to let the machine finish a folding
cycle. After the last sheet of paper is folded the machine turns off automatically.
4) Methods of folding and control of stops
Types of individual folds
Each type of paper folding requires precise setting of the stop rider 9of the X stop 6 in
an appropriate position. The position of riders of X and Y stops can be adjusted for
various types of paper. ‘Single’ folding (½)requires that the Y stop is inserted in the
machine in the opposite way.
5) Troubleshooting
Paper crumpling in the machine: First both stops must be removed from the
machine and then the crumpled sheet must be
removed in such a way that the rollers turn
round spontaneously.
Defective fuse replacement: Disconnect the supply cable from the mains
and after dismantling the cover, replace the
fuse (F 630 mA/250V)
6) Dismantling of covers
Covers can be dismantled by a qualified person only and only after the machine
has been disconnected from the mains supply.
7) Machine disposal
When the service life of the machine is over, the machine is disassembled and
its parts are sorted as follows: metal, non-metal, plastic and rubber. These
parts are then handed in at the respective collecting points for further recycling.
5
10
4
3
6
9
8
11
1
2
Marking of the main
parts of the
machine
1 – start button
2 – stop button
3 – tilting board
4 – infeed tray
5 – delivery drawer
6 – X stop
7 – Y stop
(back side)
8 – T-squares
9 – stop rider
10 – front cover
11 – back cover