Cypress PSoC CY8CKIT-029A User manual

PSOC® LCD SEGMENT DRIVE EXPANSION BOARD KIT
QUICK START GUIDE
Board Setup
1. Plug the expansion board into port A of
the CY8CKIT-001 DVK and connect the
MiniProg3 to the PSoC 3 processor
module.
2. Connect the jumper wire from port VR to
port P0_2 on the CY8CKIT-001 DVK.
3. Plug 12-V adaptor into the power jack
of the CY8CKIT-001 DVK; plug the other
end to a wall outlet to power the DVK.
Jumper Settings
1. The remaining jumper settings on the
CY8CKIT-001 DVK should be left in the
default state. Refer to the "PSoC
Development Kit Board Guide" for
default jumper settings.
2. Power on the VR by setting jumper J11
to ON position on CY8CKIT-001 DVK.
Install Software
1. Insert the kit CD and install kit
software.
2. Open the kit guide for additional
documentation, projects, and demos.
Test Board
1. Program the PSoC 3 device on the
CY8CKIT-001 DVK board with the
“Battery Meter” example project.
2. Vary the VR (potentiometer) and observe
the status changes displayed on the LCD.
1
2
3
4

© 2009-2011 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered
trademarks referenced herein are the properties of their respective owners. DOC#: 001-55143 REV *A
www.cypress.com/go/CY8CKIT-029
For the latest information about this kit visit
PSOC LCD SEGMENT DRIVE EXPANSION BOARD KIT
QUICK START GUIDE
14-Segment Alpha
Numeric Section
Medical Symbol
7-Segment Numeric
Section
Alarm Display
Wireless Symbol
Battery Charge Indicator
LCD Segment Details
Pixel Mapping Table
Segment Lettering Information
Note: The table on the board’s secondary silk screen is according to the LCD
data sheet. Read COM1 to COM8 as COM0 to COM7. See the LCD data
sheet in the Documentation folder of the kit CD for details.

Mouser Electronics
Authorized Distributor
Click to View Pricing, Inventory, Delivery & Lifecycle Information:
Cypress Semiconductor:
CY8CKIT-029A