Dakota Digital HDX-58C-IMP User manual

Manual # 650649
HDX-58C-IMP
Dakota Digital HDX Instrument Installation
For 1958 Impala
Your new HDX-58C-IMP kit includes:
Installation
Control Box
(8x) 8-32 x
1/2” Screws
Universal Sender
Pack
Installation Manuals
HDX Display
1. Remove the stock gauge cluster from the dash.
Block off Lens
Buzzer
Main Harness

Manual # 650649
3. Remove all lens and separator plates from the bezel. The odometer lens and gear indicator
lens will need to be drilled out. You should be left with a bare bezel.
Drill at these points
2. Remove the stock gauge housing from the bezel by removing the (8) eight screws on the rear
of the metal housing. The only item to be reused is the original front bezel; the other pieces
can be discarded. Now is a good time to clean or refinish the bezel.
Bare housing ready for HDX assembly

Manual # 650649
6. Re-install the cluster into the vehicle and refer to the main manual for wiring instructions to
complete the HDX installation.
4. Secure the HDX system to the bezel by using the (8) eight supplied ½” screws. Watch
carefully as you insert the system so you don’t scratch or damage the lens or switch buttons.
5. Connect the provided harness and the buzzer (optional for audio feedback) to the back of the
HDX system.
7. Removing the stock gauge eliminates the illumination for the gear indicator during headlight. The
supplied gear indicator block off lens can be used if so desired.
Buzzer Connector

Manual # 650649
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go
to www.P65Warnings.ca.gov
9. Peel off the protective paper and lay the block off lens flat in the gear indicator opening. Use
silicone to adhere the lens to the lower dash bezel.
8. With the lower dash bezel already out, remove the two mounting screws to remove the indicator
plate and lens.
10. Reassemble lower dash bezel when the silicone has cured.