Dakota Digital VHX-64P-GTO User manual

Manual # 650421B
VHX-64P-GTO
Dakota Digital VHX Instrument Installation
For 1964-’67 GTO/LEMANS/TEMPEST
Your new VHX-64P-GTO kit includes:
Installation
Control Box
(6) 2" 6-32 Pan Head Screws
(3) 1/2" 6-20 Pan Head Screws
(3) 1/2" 6-20 Flat Head Screws
CAT5 Cable
Universal Sender Pack
Installation Manuals
VHX Display
VHX Spacer
1. Remove the stock gauge cluster from the dash and save all hardware for reassembly.
(3) Block Off
Lenses
Switch Assembly

Manual # 650421B
2. Remove the stock gauges, separator plate, and lens from the bezel. The only item to be reused is
the original front bezel; the other pieces can be discarded. Now is a good time to clean or refinish
the bezel.
3. Peel the paper off the two block off lenses that
match the bezel and, on the back of the housing,
place them shiny side down in the two indicator
openings in the center (white arrows). Use silicone
to hold them in place and avoid handling until the
block off lenses are secure.
4. Place the VHX spacer over the back of the bezel so the flat side with three counter sunk holes is
facing you; make sure the counter sunk holes (white arrows) line up with the bezel mounting
points. Use the three (3) provided 1/2" 6-20 flat head screws to secure the spacer to the bezel.

Manual # 650421B
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
6. Connect the CAT5 cable to the system. As the
assembled cluster is installed into the dash, take
care when routing this cable to the control box
mounting location.
5. Secure the VHX system to the spacer with the provided six (6) 2” screws
(white arrows), and then to the bezel with the three (3) ½” pan head
screws (black arrows).
7. Re-install the cluster into the
vehicle using stock hardware and
refer to the main manual for wiring
instructions to complete the VHX
installation.