Dakota Digital VHX-66C-CVL User manual

Manual # 650382A
VHX-66C-CVL
Dakota Digital VHX Instrument Installation
For 1966-‘67 Chevelle, Malibu and El Camino
Your new VHX-66C-CVL kit includes:
Installation
Control Box
CAT5 Cable
Universal Sender
Pack
Installation Manuals
VHX Display
1. First, remove the stock gauge cluster from the dash. There are four mounting tabs on both the top and
on the bottom of the bezel that secure the assembly to the dash. Next, remove and retain the seven
screws holding the metal gauge housing to the bezel; locations are shown with arrows below.
These screws will be used to secure the new instrument panel.
Switch Assembly

Manual # 650382A
2. Remove the protective tape from the clear lens and install the VHX system into the bezel. Watch
carefully as you insert the system so you don’t scratch or damage the lens. The VHX system
should align tightly, and the lens should sit flush with the bezel. Some reproduction bezels may
require modification on the top side for the holes to line up properly.
3. Secure the VHX system to the bezel using the seven screws removed in Step One.

Manual # 650382A
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
4. Connect the CAT5 cable to the system. As the assembled cluster is
installed into the dash, take care when routing this cable to the control box.
5. Re-install the cluster into the car and refer to the main manual for wiring instructions to
complete the VHX installation.