Dancover PVC 4m Series User manual

4m Series PVC
Storage tent
Manual for
11-12-2013-SH

Safety Advice
Attention
In some countries approval is needed to set up a marquee/tent larger than 75 m2. It
is your responsibility to comply with local rules and regulations and to ensure that
the marquee/tent is assembled correctly.
In case of bad weather conditions, it is your responsibility to ensure the
marquee/tent is safely secured and that the marquee/tent does not cause damage
to others.
close to the tent.
The marquee/tent must be safely secured. We recommend you secure your
marquee/tent with straps and pegs as soon as it is assembled.
Make sure to check if the marquee/tent is covered by your home contents insurance.
Marquees/tents must be evacuated under extreme weather conditions.
In the event of snow always remove snow from the roof of the marquee/tent
regularly to prevent snow from building on the roof as heavy snow can cause the
marquee/tent to collapse.
In the event of rain there is a risk of rain puddles building up on top of the roof of the
marquee/tent. Heavy rain puddles can cause the roof to collapse. It is your responsi-
bility to ensure rain puddles do not build up. As a precaution, make sure theroof of
the marquee/tent is stretched out properly and adequately over the side frames of
the marquee/tent and remove rain water regularly.
Please always check our website for the latest safety advice and manuall.

4m storagetent manual
Part
no. m01x4m8x4m6x4m4x4
1 Middle Leg
Groundbar
pipe
Diagonal support
1174mm 25-25
Roof support
1652mm 25-25
Corner Leg
1880mm 50-50
Male doorbar
Female doorbar
Pillar
Pillar
Celling rail
1880mm
1880mm
50-50
2 4 6 8
2 Frame pole
38-38
1880mm
Frame pole
38-38
1880mm
Frame pole
38-38
2030mm
Frame pole
50-50
6 11 16 21
3-1 2 2 2 2
2 2 2 2
3-2
4
5
6 8 10 12
6
4 4 4 4
4 4 4 4
7
3 4 5 6
8
9
10
2 2 2 2
11
2 2 2 2
12
13
4 4 4 4
4 4 4 4
4 4 4 4
2 2 2 2
11-12-2013-SH

14
15-2
15-1
2 2 2 2
16
6666
17
18
3 6 9 12
2 2 2 2
C
3-way
Connector
54-42 (A)
3-way
Connector
for corner
3-way
Connector
for corner
3-way
Connector
for sidewall
4-way
Connector
54-42 (B)
eiling rail
2 2 2 2
6 8 10 12
23
24
25
26
27
28
29
30
31
Strengthen bar 4 6 8 10
Bracket 10 12 14 16
Groundbracket 4 6 8 10
Peg
400mm
8 12 16 20
Spiral peg 4 4 4 4
Long peg
10 12 14 16
Small peg 28 32 36 40
Bungeeball
long 44 44 44 44
Rope 4 4 4 4
11-12-2013-SH
4m storagetent manual
Part
no. m01x4m8x4m6x4m4x4

Screw
M6X30
8 10 12 14
Screw
M6X45
5 5 5 5
32
33
M6 Wingnut
13 15 17 19
35
Screw
M8x50mm
40 50 60 70
Screw
M8X60mm
38 46 54 62
M8 Nut 78 96 114 132
Spanner
1 1 1 1
8 12 16 20
10
Turnbuckle 4 6 8
Tit down
4 4 4 4
Steel clip
16 20 24 28
1111fooR
Endwall 2 2 2 2
37
38
39
40
41
42
43
44
45
46
11-12-2013-SH
Steel tension bar
4m storagetent manual
Part
no. m01x4m8x4m6x4m4x4

II
III
Attach one end of supported pole (1.8) to the joints
I
Select a at ground for the tent, unpack the carton and check all the parts including tubes, tent and accessories… etc.
are present and the same as the list.
Assemble the framework of rooftop by joining the portion (15-1.15-2). together with poles (2.3-1.3-2.4) NO.3 is on four
corners for diagonal pipe
15-1
15-1
15-1
15-2
4
3-2
2
3-1
3-1
22
3-2
2
2
4 4
4 4 4
4
4
15-2
15-2
15-2
15-2
15-2
15-1
15-1
15-1
15-2
15-1
15-1 15-1
7
4
15-2
15-1
15-2
8
11
12
24
24
24
24
1
1
1
11
8
12
To ensure the screw xed to every pole tightly. And then use the turnbuckle and steel tension bar to tighten
the top structure.

IV
Attach the another supported poles (1.8) to the joints, built-up the framework.
V
You facilitate the assembly and dismantling by pulling the roof with ropes ont tent frame. Use the steel clips to fasten
the cover to the frame. Each section we o er bracket and nail to fasten the frame to ground.
15-1
15-1
13
17
18
18 2
2
2
2
2
6
5
5
5
3-2
3-1
2
52
2
1
8
1
1
2
2
7
7
4
4
4
4
4
16
16
17
8
14
9
10
12
11
15-2
15-2
15-2
15-2
15-1
15-1
23

VI
Spread the wall panel and door panel attach to framework by using the bangee cords clasping the frame to grommets
that is construct over the wall panel and door panel to ensure stability. Also use the short pegs to x the doors to the
ground.
Warning
1.
In order to avoid being rusted by air, oil is covered on the surface of the
pipes, before set up
the tent, please remove the oil carefully frist to keep the
cover clean.
2. Take note that the tent needs to be handled care fully to avoid damage.
3. Do not force the frame as they may be damage in the process.
4. Tents are meant as temporary shelter and must be e
vacuated under
extreme weather conditions.
Please select a suitable site for the tent to avoid the damage to underground
sprinkler systems, water, gas or electrical lines.

Contact information
Head office:
Dancover A/S
Nordre Strandvej 119 G
3150 Hellebæk
Denmark
For more information
please visit:
www.dancovershop.com
National contact
Denmark:
[e-mail]
UK:
[e-mail]
Spain:
[e-mail]
Italy:
[e-mail]
Germany:
[e-mail]
Switzerland:
[e-mail]
France:
[e-mail]
Austria:
[e-mail]
Sweden:
[e-mail]
Finland:
[e-mail]
Nederland:
[e-mail]
Poland:
[e-mail]
Ireland:
[e-mail]
Luxembourg:
[e-mail]
Belgium:
[e-mail]
Norway:
[e-mail]