Danfoss TGE 10 User manual

Note: Only solder version, connection sizes 28 mm / 1 1/8 inch and below are approved for flammable refrigerants.
This product is approved for R290 by ignition source assessment in accordance to standard EN13463-1.
© Danfoss | DCS (az) | 2018.02
067R9603
067R9603
Installation guide
Thermostatic expansion valves
Type TGE 10, TGE 20 and TGE 40
DKRCC.PI.AXV.A7.02 | 1
Max. working pressure:
PS/MWP = 46 bar / 667 psig
Max. test pressure:
Ptest = 51 bar / 740 psig
Refrigerants:
R410A, R32, R452B, R454B, R22, R134a, R1234ze, R407F, R407A, R404A,
R507, R407C and R290
For complete list of approved refrigerants, go to www.danfoss.com
TGE 10 Balanced port design TGE 20 / TGE 40 Double balanced port design
Max. 700 °C
/ 1300 °F
Max. 110 °C
/ 230 °F
Max. 700 °C
/ 1300 °F
Danfoss 67N04.12
OK
1
2
3
Danfoss 67N17.1
2
MAH charge: 150 °C / 302 °F
N charge: 100 °C / 210 °F
K charge: 150 °C / 302 °F
1/2- 5/8inch
12 - 16 mm
3/4- 7/8inch
18 - 22 mm
1 - 1 3/8inch
25 - 35 mm
OK
Min. 5% Ag
Torx T25
Max. torque 4 Nm / 3 ft-lbf

© Danfoss | DCS (az) | 2018.02
DKRCC.PI.AXV.A7.02 | 2
Danfoss
67N06.12
Danfoss 67N18.12
Danfoss 67N07.11
TGE 10: ∆SH/360°C ≈ 1°C / 1.8 °F
TGE 20: ∆SH/360°C ≈ 1.5°C / 2.7 °F
TGE 40: ∆SH/360°C ≈ 1.5°C / 2.7 °F
Static superheat (SS) adjustment
123
+
–
Danfoss 67N40.10
TGE 20 / TGE 40
Max. torque
3 Nm / 2.2 ft-lbf
4.8 mm / 3/16 inch
TGE 10
Max. torque
3 Nm / 2.2 ft-lbf
Danfoss 67N41.10
+
–
4 mm / 5/32 inch
2
Danfoss 67N52.10
Torque = 10 Nm / 7ft-lbf
Danfoss 67N53.10
= 19 mm / 3/4inch