De Agostini MODEL SPACE Honda CB750 FOUR User manual

257
BUILD YOUR OWN
Pack 17
TM

CONTENTS
Assembly Guide
Stage 54: The drive sprocket
Stage 55: The battery box cover
Stage 56: The rear fender sticker and the base frame
259
Editorial and design by Continuo Creative, 39-41 North Road, London N7 9DP.
Published in the UK by De Agostini UK Ltd, Battersea Studios 2,
82 Silverthorne Road, London SW8 3HE.
Published in the USA by De Agostini Publishing USA, Inc., 915 Broadway,
Suite 609, New York, NY 10010.
All rights reserved © 2015
Warning: Not suitable for children under the age of 14. is product is not a toy
and is not designed or intended for use in play. Items may vary from those shown.
TM
www.model-space.com

259
Honda CB750 FOUR: Assembly Guide
Tools Prepare
Your parts
Stage 54
Base frame 5
Joint E
Carburettor tubes × 4
Drive sprocket
4 × 9mm screws with washers × 4
Type E screws × 3
The drive sprocket
Phillips screwdriver
Tweezers
Pliers
Cross wrench
Multi-purpose adhesive/spatula
Masking tape
Drive chain (Stage 30)
Rear fork (Stage 33)
Fork pivot shaft (Stage 33)
Metal nut (Stage 33)
Main stand (Stage 37)
IR sensor window (Stage 39)
Wire cables × 2 (Stage 40)
Transmission case cover (Stage 45)
Type E screw (Stage 45)
Left frame half (Stage 51)
Right frame half assembly (Stage 52)
Place the right frame half assembly with
the left side of the engine facing up. Take
the drive sprocket and align the two tabs
with the holes in the engine (arrowed).
Insert the tabs into the corresponding
holes in the engine.
Insert a type E screw (Stage 45) into the
circled hole in the drive sprocket.
Tighten the type E screw into the hole,
turning it just enough to hold the
sprocket in position.
1
2
3
4

260
Honda CB750 FOUR: Assembly Guide
Keep pushing the tube into the hole
until it stops.
Half-tighten a second type E screw into
the second hole in the drive sprocket.
Insert another carburettor tube into the
top of the second carburettor from the
left (circled).
Push the tube into the hole in the top of
the carburettor on the right.
Collect the ends of all four carburettor
tubes and tape them together.
Insert a carburettor tube into the hole
in the top of the carburettor under the
right frame half (the third one from the
left, circled).
Push another carburettor tube into the
rst carburettor (circled), as shown.
Pass the last of the carburettor tubes
underneath the right frame half, pushing
it through to the right.
5
6
7
8
9
10
11
12

261
Honda CB750 FOUR: Assembly Guide
Remove the chain cover from
the swingarm.
Take the fork pivot shaft (Stage 33) and
insert it into the circled hole in the right
frame half.
Place the brake rod joint over the rear
brake spindle (shaded).
Hold the swingarm against the frame
and push the shaft all the way through.
Insert the pivot shaft into the swingarm,
on the brake side.
Push the shaft all the way through
the hole.
Place the drive chain into the teeth of
the drive sprocket.
Clip the joint into the spindle.
13
14
15
16
17
18
19
20