Defender EL00019 User manual

WINDOW SHOCK ALARM
Electronic Security System for Windows Product Code: EL00019
solonsecurity.co.uk
Introduction
The Window Shock Alarm is a convenient, easily to use alarm designed to increase the safety of your
home. The alarm is intended to provide both a visible deterrent by the use of an adhesive warning sticker
and an audible deterrent should there be an attempted forced entry.
Operation of the alarm
1. Using the double sided adhesive sticker mount the Window Shock Alarm on the glass of the
window (or door) to be protected.
2. To arm the unit toggle the switch to the “Hi” or “Lo” position. “Hi” position provides a greater
sensitivity for a large window. “Lo” position is more suitable for a small window.
3. To test, gently knock on the window in several places. The Window Shock Alarm will sound.
Note:
When testing, a cloth can be used to cover the alarm siren to reduce the risk of hearing damage.

Battery test and replacement
It is recommended that the alarm is tested regularly. If the alarm sounds weak, the batteries should be
replaced.
1. Toggle the switch to “Hi” or “Lo”
2. Push the test button on the front of the Window Shock Alarm.
3. If the red light illuminates, the batteries are still good.
4. If the light fails to illuminate then please replace the batteries.
The unit operates by 4 x LR44 (or equivalent) button batteries.
5. Slide o the battery compartment cover.
6. Remove the old batteries and replace with fresh ones. Important – do not mix old and new batteries
as this seriously aects the performance of the Window Shock Alarm.
7. Replace the battery compartment cover and follow the test procedure above.
Remove batteries before storing this device for extended periods. Batteries will corrode over time and
may cause permanent damage. Depleted batteries should be disposed of properly.
Care and Maintenance
To clean the Window Shock Alarm housing use a soft cloth that has been slightly dampened with water
and wipe. Do not use chemical agents as they may damage or discolour the plastic housing.
CAUTION
• When testing the alarm, make sure you cover the siren.
• The power source or propellant has a finite / limited life.
• DO NOT MODIFY THE ALARM.
• The alarm should be kept out of reach and audible range of children and pets.
Note:
Performance may be adversely aected following prolonged exposure to extreme temperatures.
WARNING
The high output siren fitted to this quality personal alarm may cause ear damage if used at close
range for a prolonged period of time. Keep away from children and pets ears. This product is
designed for use as a deterrent; it does not guarantee protection or personal safety.
Solon Security
Unit 40
Manor Industrial Estate
Flint, Flintshire
CH6 5UY
solonsecurity.co.uk