DeVilbiss Healthcare Drive AutoFold User manual

QSG - Autofold Powerchair. Issue: 2022-04 Rev2
CONTACT INFORMATION
Drive DeVilbiss Healthcare Ltd., Sidhil Business Park, Holmeld,
Halifax, West Yorkshire, HX2 9TN, GB
Tel: [phone]
Email: [email protected].uk
www.drivedevilbiss.co.uk
Drive DeVilbiss Healthcare Ltd. provide these instructions for use.
Sungo Europe B.V.
Olympisch Stadion 24, 1076 DE, Amsterdam, NL
Zhejiang Innuovo Rehabilitation Devices Co., Ltd
No. 196 Industry Road, Hengdian Movie Zone,
Dongyang, Zhejiang, CN
Drive DeVilbiss Sidhil Ltd.
4 Trench Road, Mallusk, Newtownabbey,
BT36 4TY, UK
Sungo Certication Company Ltd
70 Gracechurch Street, London, EC3V 0HR, GB

AutoFold Powerchair
QUICK START GUIDE

1. Unpack the powerchair and place the
powerchair so the front is on the floor.
2. Install joystick. Turn the securement
knob to loosen. Insert the joystick tubing.
When the required position is reached,
tighten the knob to secure.
3. Add the cable clips to the frame.
4. Connect the battery lead and controller lead together.
Check that the battery is locked in position, underneath
the seat.
5. Unfold the powerchair. At the rear of the chair, set the
right hand switch to ‘I’. On the left hand switch, continu-
ally press the side marked ‘II’, until the powerchair is fully
unfolded. Return the right hand switch to ‘O’.
6. Install battery in remote fob (CR2032). Open the
battery compartment. Insert the CR2032 battery and
then press together the plastic housing to lock. (Note:
for some markets, the battery may already be installed).

7. Put freewheel levers into ‘Electric’ mode by
pushing the levers forward. Repeat for both
motors.
8. Drop down armrests and pull-down
footrest.
9. Install the seat and back cushions which
attach with Velcro (if required)
10. Charge battery. The battery can be charged via the
powerchair by inserting the charger into the socket on
the underside of the joystick. The battery can also be
charged directly when removed from the powerchair.
(See section 8.3 of the Instructions for use for more
details).
11. Switch the powerchair on using the joystick. Ensure
the charger is removed before operation.
12.Using the remote fob after
initial set up.
To unfold the powerchair:
• Press
• Press
• Press and hold until motion has
finished.
To fold the powerchair:
• Press
• Press
• Press and hold until motion has
finished.
To unfold powerchair To fold powerchair
(See section 8.3 of the Instructions for use for more
details).
Follow these instructions to safely set up your new powerchair
NB. images are for illustration and parts identification purposes only, and may not reflect final
product outlook and /or appearance.