Dimplex XLS User manual



ContactDetails

Pleasenotethatsomeofthecontactdetailson
thisPDFdocumentmaynotbecurrent.

Pleaseusethefollowingdetailsifyouneedto
contactus:

Telephone:08448793588
Email:[email protected]


Thecustomersupportsectionofourwebsitealsofeaturesawide
rangeofinformationwhichmaybeofusetoyouandisavailable
24hoursaday.Itincludes:

•Operatingandinstallationinstructions
•Easy‘Howtouse’guidesforstorageheaters
•Serviceandrepairs
•Wheretobuyourproducts
•Literaturedownloads
•Heatingrequirementcalculator

Visit‐www.dimplex.co.uk/support
A division of GDC Group Ltd
Millbrook House Grange Drive Hedge End Southampton SO30 2DF
www.dimplex.co.uk
Re
g
istered No: 1313016 En
g
land
VAT GB 287 1315 50004
EEE Producer Registration Number –
WEE/GE0057TS
Paper from sustainable sources

Quick Start Guide
XLS and CXL Storage Heaters QS031
This guide is for quick reference only. Refer to the appropriate installation and operating instructions for further information
XLS storage heater Heater controls
Dimplex UK Ltd, Millbrook House, Hedge End, Southampton, SO30 2DF. For further assistance please contact Dimplex customer services on 0845 600 5111. Web-site: www.dimplex.co.uk
WARNING: Walls, curtains and furniture should be at least 75mm away from the top and sides of the heater. Furniture and other
obstructions should be at least 150mm from the front of the heater. DO NOT COVER or obstruct the air inlet or outlet grilles.
PLEASE REFER TO THE OPERATING AND INSTALLATION INSTRUCTIONS FOR FURTHER SAFETY ADVICE.
Input control — controls the temperature of the heater
Adjust control for the first few days until your ideal room
temperature is found, then leave on this setting. Heater will
automatically adjust for changing weather.*
Boost control — controls the amount of heat given later
in the day
Normally leave boost setting at minimum. Turn up if more heat
is required later in the day. Leaving the control on a higher
setting will provide automatic boost each day.
On/Off switch
Leave on for heating season
CXL storage heater and control position Heater controls
Input control — controls the temperature of the heater
Adjust control for the first few days until your ideal room
temperature is found. The higher the setting, the warmer your
heater will get.*
Boost control — controls the amount of
heat given later in the day
Normally leave boost setting at minimum.
Turn up if more heat is required later in the
day. Leaving the control on a higher setting will
provide automatic boost each day.
Storage on/off switch
Leave on for heating season
Convector boost heat setting
Thermostat control to select your chosen
comfort level.
Convector boost on/off switch
Switch it on if top up heat is required.
Neon light shows when boost is selected.
Convector on/off switch
Leave on
* NOTE: Changes to the input control setting will not come in to
affect until the next period of off peak (cheap rate) electricity is
available.
If you are unsure when your off peak supply is available, contact
your electricity provider.