Displays2go LCKDPZTRBK2 User manual

1
Sandwich one of the “Thank You” doors between the two side panels by
putting one of the pegs into the hole at the top of the door and wedging
the other side panel slightly to get the other peg into the other hole. The
“Thank You” door should swing freely between the two pegs.
To lock the cams together, slide the peg into the opening in the cam and
with a Philips head screwdriver, turn the cam clockwise to lock in place.
Cams and Pegs
Hinge
Drop side panel (B) into back panel (D) and lock all 4 cams. Do the same
with side panel (C) and lock all 4 cams.
3
Hardware
Side Panels (B) (C)
Back Panels (D)
Kicker (N)
LCKDPZTRBK2 –Trash Receptacle, Black
LCKDPZTRSM2 –Trash Receptacle, Mahogany
LCKDPZTRMP2 –Trash Receptacle, Maple
Panel (M)

2
Scan QR code to visit
the product page:
If you have any questions regarding our products, please visit us at
www.displays2go.com or contact D2G customer service 844-221-3388.
Attach base panel (J) by dropping it in between side panels and slide
toward bottom and lock in place. Drop kicker (N) onto pegs below base
and lock in place
Thank You Doors
Drop top panel (I) onto the top of the unit and lock all cams. Drop panel
(M) onto pegs below the “Thank You” door and lock all cams.
6
Attach hinges to Door (O) using pointed screws. Attach the door to the
side panels. Insert glides to the bottom of the side panels and middle
panel and use a rubber mallet as needed.
Base Panel (J)
Top Panel (I)
Doors (O)
LCKDPZTRBK2 –Trash Receptacle, Black
LCKDPZTRSM2 –Trash Receptacle, Mahogany
LCKDPZTRMP2 –Trash Receptacle, Maple
Plastic Glide