Displays2go WRADC User manual

Assembly Instructions
URBAN EDGE DISPLAY CASE
SKU WRADC
Scan the QR
code to visit the
product page.

PART QUANTITY
Side Panel (A, B)........................................................................................................................................2
Wood Shelf (C, D, E, F, G, H)...................................................................................................................6
Acrylic Panel (I, J) ......................................................................................................................................2
Acrylic Door (K, L) .....................................................................................................................................2
Door Hinge.................................................................................................................................................2
Lock Components ......................................................................................................................................2
Slotted Screw ...........................................................................................................................................20
Key ..............................................................................................................................................................2
Assembly
1. Lie side panels A and B on the floor. Place shelves E and H at indicated positions. Orient shelves
and side panels as shown below, with shelf channels facing the up and to the front, opposite
from slots on panels.
2. Secure shelves with slotted screws. Hand-tighten, and do not tighten slotted screws fully until the
end of the assembly.
3. Connect acrylic side panel B to shelves.
2 people recommended for assembly.
Tools Required: Philips screwdriver (not included)
H
(Bottom)
E
B
A

4. Lift the unit to standing position.
5. Slide glass panel I down into channel of shelf E.
6. Slide glass panel J down into channel of shelf H. Holding panel J, slide shelf F into position, then
secure shelf F with slotted screws to keep panel J in place. Hand-tighten screws.
I
I
J
E
H
12

7. Attach shelf C with hole for door hinge facing down with slotted screws. Hand-tighten screws.
8. Attach the rest of the shelves using slotted screws. Hand-tighten screws.
I
D
E
F
C
G
H
C
J
E
F
12

1 2
34
9. Assemble door lock components on acrylic doors (K, L). Add lock and secure with washer. Then
attach locking tab. Secure all pieces with crosshead screw.
10. Repeat on other door.

If you have any questions regarding our products, please visit us at www.displays2go.com or
contact Displays2go customer service at 844-221-3388.
Assembly is complete.
11 . To attach acrylic doors, insert lower door hinge into hole on shelf. Place the upper hinge on the
glass door and slide door into place. Push the door flush against the shelf to properly align the
door. Screw each door hinge to secure door in place.
12. Repeat on other acrylic door.
13. Fully tighten all slotted screws. Use a coin or flat object to tighten carefully and avoid scratching
the surfaces of the screws.
1 2
K