Displays2go LCTKD User manual

Hardware:
- Cam & Connecting Bolts (14 required)
Components:
(1) Front Panel
(2) Side Panels
(1) Top Platform w/ Lip
(1) Shelf
Step #1
It's easiest to begin by laying out all the panels on
a carpeted area as shown in the diagram below.
Step #2
While still on the floor, begin inserting the (14) cams & connecting
bolts into the panels. The cams should be inserted so that the
opening of the cam is facing toward the respective opening on
the edge of the panel. All connecting bolts should be threaded
into the inserts on the required panels.
Before beginning the assembly, lay out all hardware & components and please make sure that all
pieces listed on this instruction sheet are present and accounted for. Extra hardware is common.
Side
Panel
Side
Panel
Front
Panel
Top
Platform
Shelf
Shelf... (4) cams
Top Platform...
(4) connecting bolts
Side Panel...
(5) connecting bolts
(2) cams
Front Panel... (6) cams
LCTKD Assembly Instructions
SHEET 1 OF 2

Step #3
(A) With the Front Panel lying down & cams inserted, take one of the Side Panels and align the connecting bolts with
the holes on the Front Panel. Use a screwdriver to tighten the cams & lock them into place. (B) Next, attach the shelf
using the same technique... align the connecting bolts up with the holes & tighten cams. (C) Finally, attach the
second Side Panel by aligning the connecting bolts with the holes on both the Front Panel & Shelf... tighten cams.
Step #4
Stand the lectern into an upright position.
Position the Top Platform so
that the connecting bolts align with the holes on the angled edge
of the Side Panels... tighten cams.
(A)
(B)
(C)
LCTKD Assembly Instructions
SHEET 2 OF 2