Displays2go RNDH B1548 User manual

RNDH B1548 -15’w x 48”h
Circular Hanging Banner
Assembly Instructions
Parts list:
A: (18) Long Bars (Top/Bottom)
B: (9) Short Bars (Middle)
C: (9) Long Screws
D: (9) Short Screws
E: (1) Wirerope
+ Extra / Replacement pieces.
Connect (7) Long Bars (A) end to end
to form a closed ring. Repeat this step
to form another ring.These are the top
and bottom supports for your graphic.
Choose one of the circular rings and
align the Short Bars (B) with the holes
in the middle of each section.
Please Note:Make sure that Middle
Supports (B) are bowing inward
towards the center of the ring.
Please Note:Button Locks should be
facing downwards when assembling
top frame,and upwards when
assembling bottom frame.
Attach ring to middle supports (B)
using the short screws (D).
Set the assembled ring on the ground
so the Short Bars (B) are facing upward.
Position your unzipped graphic
underneath the ring.
Position your graphic so the center
seam is aligned with the bottom ring
and the printed side faces outwards.
Raise the outside of the graphic up
so it rests on the tips of the short poles.
With the help of another person rest
the 2nd ring on top of the middle
supports and drape the banner over
the ring. Make sure to keep the banner,
ring, and support holes aligned.
D (x9)
C (x9)
A (x18)
B (x9)
B
D
A
A
Once all long screws are in place, lift
the inside of the graphic and zipper
The sections together.
Hang your Banner by clipping the
included wire to the eyelets on top
of each long screw.
Please Note: Align each of the
re-enforced holes with the top of
each short pole (B)
Align all holes then insert long screw and hand tighten.
A
B
A
Button
Lock
Button
Lock
A
A
A
A
A
A
A
A
A
A
B
B
B
B
B
B
B
B
B
A
A
A
A
A
A
A
A
C
C
C
C
C
C
C
C
C
D
D
D
D
D
D
D
D
D

A
A
A
A
A
A
A
A
A
A
B
B
B
B
B
B
B
B
B
A
A
A
A
A
A
A
A
C
C
C
C
C
C
C
C
C
D
D
D
D
D
D
D
D
D