dji Phantom 2 Vision + User manual

Place the Phantom on its head
(make sure battery is removed)
Remove jack plug out of the camera
Pull the frame careful out of the rubber holders
(Careful: there is a wire connected to the camera)
Manual DJI Phantom 2 Vision Dronexpert Gimbal

Disconnect the camera connector
Remove the frame for the Phantom body
You will have now removed camera and frame:

Remove white rubber cover and loosen (remove) the screw
Remove the vision camera from the frame
Remove the plastic inlay

Place screw back screw with the inlay in the frame so you do not lose it.
Place the outside rubber cover back on the Vision camera.
Overview photo

Now take the gimbal and included parts out of the case
Put rubber tubes in the camera (where screws are located). Press the
tubes all the way down to the end.
Place the camera (jack) connector as show on the images

Place the screws in the rubber tubes as shown on the image

Now put the jack connector into the vision camera.
IMPORTANT: Make sure the sensor plate is mounted horizontal

Paste the cable extender on the belly of the Phantom as shown on the
image and connect it. Make sure you keep enough space for you Phantom
battery.
Move your compass to a lower position

Paste dampers in the corners of the landing gear as shown below
Now place the gimbal mount between the landing gear, first one side then
the other side. The landing gear of the Phantom is quite flexible. The right
landing gear and pull it with fixed-close strength aside and place the
mount on its place as shown on the image below