Dura Trel 11182 User manual

4’ x4’ Three Board
planter BEd
Model# 11182 Assembly Instructions
General Information:
» Read through carefully before beginning assembly.
» When assembling components, place on a clean, flat,
non-abrasive surface to avoid scratches.
» In the event of missing or defective parts, please call our
customer service department directly at 1-877-258-6020
Tools required:
» Cordless Drill with #2 phillips bit
» Tape measure
» Shovel
» PVC or Super Glue
Part # Description Qty
1 4” sq. x 24” Corner Post 4
2 1½” x 5½” x 48” Rail 6
3 1½” x 5½” x 45” Rail 6
4 4” sq. Flat Post Cap 4
5 Hardware Kit (includes):
2” Kappet Screws 48
Kappet Screw Caps 48
Parts List:
FIGURE 1
Part identification
FIGURE 3
Product Dimensions
FIGURE 2
Product Planting
Dimensions

Insert ends of three 1½” x 5½” x 48”
rails (part 2) into two 4” x 4” x 24”
corner posts (part 1).
Apply PVC or super glue to inner
edges of four 4” sq. flat post caps and
place on top of each post.
To install, dig four holes 6” deep
according to product dimensions in
figures 2 and 3.
1
2
3
4
Using 2” kappet screws, screw
together planter bed side. Snap
kappet screw caps over screw
heads. Be sure all parts are fully
inserted into posts before securing.
REPEAT steps 1 and 2 with
remaining three 48” rails and corner
posts.
Insert ends of six 1½” x 5½” x 45”
rails (part 3) into remaining routed
holes of corner posts to form planter
bed.
Using 2” kappet screws, screw
together planter bed. Snap kappet
screw caps over screw heads.
Be sure 45” rails are inserted to
meet 48” rails. Six 45” rails will not
fully insert into posts.