Dura Trel Oxford User manual

Model# 11175 Assembly Instructions
Part # Description
max 5 x 3.5 12" sq. x 65" Corner Post
22" sq. x 59½" Left Post
32" sq. x 59½" Right Post
4⅞ x 1½ x 20" Top/Bottom Cross Rail
5⅞ x 1½ x 19" Bent Top
6¼ x 1½ x 49" Vertical Slat
7¼ x 1½ x 19¼" Horizontal Slat
82" sq. x 14" Vinyl Ground Anchor
9Hardware Bag (includes:)
2" sq. Post Cap
¾" Painted Screw
PLEASE READ THROUGH BEFORE BEGINNING ASSEMBLY.
IMPORTANT: Check boxes for Contents Listed
Check inside of parts as some parts are packaged
inside of others
In the event of missing, damaged or defective parts
please call our customer service dept. at 1-877-258-6020
When assembling components, place on a clean, flat
non-abrasive surface to avoid scratches
…
Battery or Electric Drill
with #2 phillips bit
…Tape Measure
…
Hammer or Rubber Mallet
(recommended)
…PVC, Super, or Crazy Glue
150 Birch Road
P.O. Box 122
Sheboygan Falls, WI 53085
1
1
Qty
1
Oxford Trellis
3
1
4
12
4
2
General Information
3
8
www.dura-trel.com
[email protected]
Tools Required
1-877-258-6020
1

150 Birch Road
P.O. Box 122
Sheboygan Falls, WI 53085
1-877-258-6020
2
www.dura-trel.com
[email protected]
Please call manufacturer direct with questions concerning missing or defective parts at Toll Free: 877-
258-6020.
Dura-trel, Inc. products are warranted to be free from manufacturing defects resulting in delaminating,
peeling, flaking, corroding, cracking, crazing, or extreme amounts of fading or bleaching causing the PVC
to change to its natural color for a period of 20 years from the date of purchase.
Normal weathering is defined as exposure to sunlight and extremes of weather and atmosphere which
will cause any colored surface to gradually fade.
CONDITIONS NOT COVERED BY THIS WARRANTY:
A. Physical abuse, misuse, neglect, or improper storage.
B. Improper installation or installation not in strict adherence to the instructions written by Dura-Trel,
Inc.
C. This warranty does not apply if materials are painted, varnished, or coated with any substance.
D. Dura-Trel, Inc. is not responsible for damages to product during shipping.
E. Damage attributable to atmospheric pollutants, hail, lightning, hurricane, tornado, wind borne
objects, earthquake, fire, mildew, casualty, act of God, building or ground settlement, or subjection to
stress or weight.
CLAIMS AND REMEDIES:
If a Dura-Trel, Inc. product is determined to have a manufacturing defect which is covered by this
warranty, Dura-Trel, Inc. will replace the material containing the defect (labor not included) F.O.B from
the point of manufacture. Dura-trel, Inc. will not be responsible for any cost incurred in the removal or
reinstallation of the product.
Important: An claims must be sent to the following address and should describe the defect claim.
Dura-Trel, Inc., P.O. Box 122, Sheboygan Falls, WI 53085
Dura-Trel, Inc. reserves the right to discontinue or change its design, and or color. If the original color or
style is not available, Dura-Trel, Inc. shall have the right to substitute a product designated by Dura-Trel,
Inc.
Dura-Trel, Inc. shall not be liable for any incidental, special, or consequential damages arising out of the
use of these products
Warranty Statement
20 Year Guarantee

3
Oxford Trellis
Starting at the bottom of 59½" left post (part 2) insert one 20" top/bottom cross rail (part 4) and six 19¼"
horizontal slats (part 7). Starting at top, weave one 49" vertical slat (part 6) above and below horizontal slats,
inserting end into bottom cross rail. Weave a second 49" vertical slat (part 6) above and below horizontal
slat opposite previous slat, inserting end into bottom cross rail. Insert one 20" top/bottom cross rail (part 4)
and one 19" bent top (part 5) into holes at top of post, inserting free ends of vertical slats into top cross rail.
REPEAT using remaining 20" top/bottom cross rail (part 4), 49" vertical slats (part 6), 19¼" horizontal slats
(part 7), 19" bent top (part 5) and 59½" right post (part 2) to make right side.

Oxford Trellis
4
Insert left and right trellis panels (from Page 3) into 65" corner post (part 1). In order for trellis to look
symmetrical, top/bottom cross rails, horizontal slats and bent tops must be fully inserted into 59½" left and
right posts. Using two ¾" screws per outer post and four ¾" screws for corner post, fasten together trellis. Using
PVC, super or crazy glue, apply glue to inner corners of each 2" sq. post cap and place on top of each post.
INSTALLATION
In desired location set trellis in place and mark where ground anchors will need to be inserted. Using a block of
wood to protect ground anchors; pound each anchor into place. (If ground is extremely hard, loosen or soak soil
before inserting ground anchors). Set trellis into ground anchors.
If combining with Model# 11187 Corner Slat Planter to make a planter trellis, use a straight blade screwdriver to
pop off three 2" sq. post caps and slide trellis over the planter legs.