Dura Trel Princeworth Pergola 11302 User manual

Model# 11302 Assembly Instructions
Part # Description Box#
max 5 x 3.5 14" sq. x 93" Post 1
21½ x 5½ x 106" Bottom Support Rail 2
31½ x 5½ x 106" Upper Support Rail 2
4⅞ x 3 x 106" Top Cross Rail 2
5
1½" Upper Support Bracket 3
64" sq. New England Post Cap 3
7
5½" Top End Cap 3
830" Steel Ground Anchor (U-shaped) 1
9Hardware Bag (includes:) 3
⅞ x 3" End Cap
2" Painted Screw
1¼" Painted Screw
¾" Painted Screw
#8 - 1" Painted Self Tapping Screw
PLEASE READ THROUGH BEFORE BEGINNING ASSEMBLY. PVC Glue Can
IMPORTANT: Check boxes for Contents Listed
Check inside of parts as some parts are packaged
inside of others
In the event of missing, damaged or defective parts
please call our customer service dept. at 1-877-258-6020
or e-mail [email protected]m
When assembling components, place on a clean, flat
non-abrasive surface to avoid scratches
…
Battery or Electric Drill
with #2 phillips bit
…Tape Measure
…
Hammer or Rubber Mallet
(recommended)
…
Shovel or Post Hole Digger (recommended)
150 Birch Road
P.O. Box 122
Sheboygan Falls, WI 53085
1
2
6
Qty
4
Princeworth Pergola
4
1
4
16
9
8
54
General Information
32
18
48
8
www.dura-trel.com
[email protected]
Tools Required
1-877-258-6020
1

150 Birch Road
P.O. Box 122
Sheboygan Falls, WI 53085
1-877-258-6020
2
www.dura-trel.com
[email protected]
Please call manufacturer direct with questions concerning missing or defective parts at Toll Free: 877-
258-6020.
Dura-trel, Inc. products are warranted to be free from manufacturing defects resulting in delaminating,
peeling, flaking, corroding, cracking, crazing, or extreme amounts of fading or bleaching causing the PVC
to change to its natural color for a period of 20 years from the date of purchase.
Normal weathering is defined as exposure to sunlight and extremes of weather and atmosphere which
will cause any colored surface to gradually fade.
CONDITIONS NOT COVERED BY THIS WARRANTY:
A. Physical abuse, misuse, neglect, or improper storage.
B. Improper installation or installation not in strict adherence to the instructions written by Dura-Trel,
Inc.
C. This warranty does not apply if materials are painted, varnished, or coated with any substance.
D. Dura-Trel, Inc. is not responsible for damages to product during shipping.
E. Damage attributable to atmospheric pollutants, hail, lightning, hurricane, tornado, wind borne objects,
earthquake, fire, mildew, casualty, act of God, building or ground settlement, or subjection to stress or
weight.
CLAIMS AND REMEDIES:
If a Dura-Trel, Inc. product is determined to have a manufacturing defect which is covered by this
warranty, Dura-Trel, Inc. will replace the material containing the defect (labor not included) F.O.B from
the point of manufacture. Dura-trel, Inc. will not be responsible for any cost incurred in the removal or
reinstallation of the product.
Important: An claims must be sent to the following address and should describe the defect claim.
Dura-Trel, Inc., P.O. Box 122, Sheboygan Falls, WI 53085
Dura-Trel, Inc. reserves the right to discontinue or change its design, and or color. If the original color or
style is not available, Dura-Trel, Inc. shall have the right to substitute a product designated by Dura-Trel,
Inc.
Dura-Trel, Inc. shall not be liable for any incidental, special, or consequential damages arising out of the
use of these products
Warranty Statement
20 Year Guarantee

3
Princeworth Pergola
1
2
3
Insert ends of two upper support rails
(part 3) through top routed holes of
posts.
[Upper support have seven equally spcace
pilot holes drilled in top edge.]
Do not screw together at this time.
Lay out one lower support rail (part 2).
[Lower support has six pilot holes drilled in
top edge.]
Using ¾" painted screws, fasten four
upper support brackets (part 5) to
lower support.
Insert ends of lower support rail
through bottom routed holes of two
posts (part 1).
Do not screw together at this time.
REPEAT steps 1 and 2 using remaining
lower support, upper support brackets
and posts.

Princeworth Pergola
4
Using 2" painted screws,
screw together all posts and
supports.
Lay two cross rail (part 4) onto
upper supports. To set width
of pergola, line up outer most
holes of top rails with outer
most pilot holes of upper
supports. Using 1¼" painted
screws, fasten top rails to
upper support.
4
5
6
Slide four remaining upper
support rails (part 3) through
upper support brackets,
underneath top rails.

Princeworth Pergola
5
Using 1¼" painted
screws, fasten top cross
rails to upper supports.
[This will center remaining
upper supports.]
7
8
9
Using 1 ¼" painted
screws, fasten
remaining top cross rails
(part 4) to upper
supports.
Using included PVC
glue, glue post caps
(part 6) to top of posts.
Glue support end caps
(part 7) to ends of
upper and lower
supports. Last, glue ⅞x
1½" end caps to ends of
cross rails.

Princeworth Pergola
6
PERGOLA INSTALLATION
Option 1
Slide one 30” steel ground anchor (part 8) into
bottom of each post. Slide ground anchor about
12 inches into post, leaving 18 inches for in-
ground. Using 1” painted self-tapping screws
fasten post to ground anchor.
Dig holes approximately 18 inches deep. Set
pergola in holes and level. Back fill with soil
removed from holes. For permanent installation
fill with cement.
Option 2
Pound ground anchors into ground according to
dimensions. When pounding into ground, use
block of wood to prevent ground anchor from
bending.
Slide pergola over ground anchors. Using 1”
painted self-tapping screws fasten post to
ground anchor.
Option 3
Dig holes 18” deep according to dimensions. Fill
with cement and place ground anchors in wet
cement. Be sure that ground anchors are
straight and in accordance with dimension in
figure 1. Allow cement to dry. NOTE: There is
very little room for error with this installation
method.
Slide pergola over ground anchors. Using 1”
painted self-tapping screws fasten post to
ground anchor.
10