Dura Trel 11183 User manual

4’ x8’ Three Board
planter BEd
Model# 11183 Assembly Instructions
General Information:
» Read through carefully before beginning assembly.
» When assembling components, place on a clean, flat,
non-abrasive surface to avoid scratches.
» In the event of missing or defective parts, please call our
customer service department directly at 1-877-258-6020
Tools required:
» Cordless Drill with #2 phillips bit
» Tape Measure
» Shovel
» PVC or Super Glue
Parts List:
FIGURE 1
Part identification
FIGURE 3
Product Dimensions
FIGURE 2
Product Planting
Dimensions
Part # Description (Box Number) Qty
1 4” sq. x 24” Corner Post (2) 4
2 4” sq. x 24” Line Post (2) 2
3 1½” x 5½” x 96” Rail (1) 6
4 1½” x 5½” x 45” Rail (2) 6
5 4” sq. Flat Post Cap (2) 6
6 Hardware Kit (includes): (2)
2” Kappet Screws 60
Kappet Screw Caps 60

Insert three 1½” x 5½” x 96” rails
(part 3) through one 4” x 4” x 24”
line post (part 2). Insert ends of
96” rails into two 4” x 4” x 24”
corner posts (part 1). Slide line
post to center of rail using
dimensions shown in figure 2.
Apply PVC or super glue to inner
edges of six 4” sq. flat post caps
and place on top of each post.
To install, dig six holes 6” deep
according to product dimensions
in figures 2 and 3.
1
2
3
4
Using 2” kappet screws, screw
together planter bed side. Snap
kappet screw caps over screw
heads. Be sure all parts
are fully inserted into posts
before securing.
REPEAT steps 1 and 2 with
remaining three posts and
three 96” rails.
Insert ends of six 1½” x 5½” x 45”
rails (part 4) into remaining routed
holes of corner posts to form
planter bed.
Using 2” kappet screws,
screw together planter bed.
Snap kappet screw caps
over screw heads. Be sure
45” rails are inserted to
meet 96” rails. Six 45”
rails will not fully insert into
posts.