DXV Lowell D20070001 User manual

- 1 -
INSTALLATION INSTRUCTIONS
SAVE FOR FUTURE USE
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2017 7302302-100 Rev. A (6/17)
Thank you for selecting DXV. To ensure this product is installed properly, please read these instructions carefully before you begin.
(Certain installations may require professional help.) Also be sure your installation conforms to local codes.
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY, HANDLE WITH CARE!
NOTE: Pictures may not exactly define contour of china and components.
Visit www.DXV.com for French and Spanish Installatio Instructions.
!
Lowell™
Console Lavatory Kit
Models: D20070001 — Single-Hole Lavatory
D20070008 — Three-Hole Lavatory
D21420026 — 26" Console
D28005000 — Towel Bar (optional component)
Lowell Lavatory can be installed without console
FINISHED
WALL
1-3/8" D. (35 mm)
FAUCET MOUNTING
HOLES
21"
(535 mm)
26"
(659 mm)
2-3/4"
(70 mm)
9"
(230 mm)
8"
(203 mm)
18-1/4"
(464 mm)
1-3/4" D.
(45 mm)
15-3/4"
(401 mm)
FINISHED
FLOOR
22-7/16"
(570 mm)
1"
(25 mm)
FRONT/REAR BARS
ø 18.5 mm on both sides
ø 25 mm at the center
23-1/16"
(585 mm)
20-5/16"
(570 mm)
6-5/16"
(160 mm)
3/4"
(19 mm)
1-1/16"
(27 mm)
34-5/16"
(872 mm)
7/8" (22 mm)
8"
(203 mm)
22-3/4"
(578 mm)
20-1/2"
(521 mm)
SUPPLIES AS
REQUIRED
1-1/4"O.D.
WASTE
1-1/4"O.D.
TAILPIECE
RECOMMENDED TOOLS AND MATERIALS
Most of the procedures require the use of common tools
and materials, which are available from hardware and
plumbing supply stores. It is essential that the tools and
materials be on hand before work is begun.
REPLACEMENT USE
When replacing an original unit, be certain to shut-off water
supplies before removing the unit or disconnecting water
supply lines and drain ttings. Original supply lines and
shut-off valves should be replaced and used with ttings
and adapters to match the hookups on the
replacement unit.
USE TEFLON SEALANT TAPE ON PIPE THREADS
FOR WATERTIGHT CONNECTIONS!
ROUGHING-IN DIMENSIONS:
• For reference
!
Adjustable WrenchChannel Locks
Regular Screwdriver
Phillips Screwdriver
10'
Saber Saw
Pipe Wrench
Level
Tubing Cutter Square
Tape Measure
Electric
Drill
1 2 3 4 5 6 7 8 9 10 11
12345678910
11 12 13 14 15 16 17 18 19 20 21 22 23 24
Hacksaw
Sealant

- 2 -
7302302-100 Rev. A (6/17)
1
2
INSTALLATION PROCEDURES
INSTALLING LAVATORY
Typical installation includes wall preparation lavatory mounting, installation
of faucet and pop-up drain, supplies to house water system.
Lavatory Mounting Provisions - Whether the lavatory is used for
replacement or new installation, the wall area behind the lavatory basin
mounting holes must be reinforced to provide secure mounting for
the new unit.
Preparing Wall for Lavatory Mounting
Optional: For non-masonary installation, crosspieces must be
installed to reinforce the lavatory mounting surface to provide
adequate support, install as described below.
1. Remove wallboard/covering from designated area.
2. Toenail 2" x 6" (51 x 152 mm) cross piece between studs (or notch studs
to accept a 1" x 6" (25 x 152 mm) crosspiece, and attach securely).
C/L of reinforcement should be 34" (863 mm) up from nished oor.
3. Replace wallboard/nished wall media.
CAUTION: Lavatories are extremely heavy. For personal safety, always use an textra person for installation.
1. Using level, draw a vertical line starting at the waste water return hole.
Draw a horizontal line at the required dimension from oor. Check the
dimension placing the lavatory and console into position. Mark and drill
holes through the mounting holes along the horizontal line. Install lavatory
anchor screws leaving 1-7/8" threaded end exposed as illustrated.
2. Apply a bead of silicon to the back of the lavatory. See Diagram.
3. Pre-assemble P-trap drain connections in accordance with manufacturer’s
instructions. Check that pop-up drain opens and closes properly when drain
control is operated. Connect supply lines to shutoff valves and loosely install
drain connections.
1-7/8"
(48 mm)
Anchor Screw
Washer
Lavatory
Nut
Bead of Silicon
Geometry shown is for illustration only
and may not match product geometry.
P.TRAP
COMPRESSION
WASHER
NUT
NUT
COVER
HOUSE DRAIN
PIPE FITTING
LAVATORY
POP-UP DRAIN
TAILPIPE
TYPICAL DRAIN
CONNECTIONS
TYPICAL WATER
SUPPLY LINE
CONNECTIONS
SPREAD LAVATORY SET
TYPICAL APPLICATION
FLEXIBLE
SUPPLY LINE
HOT SHUTOFF VALVE
COLD SHUTOFF VALVE
FLEXIBLE
SUPPLY LINE
STUDS OR
TOE-NAIL
DRAIN PIPE
WATER
SUPPLY
PIPES
CROSS-PIECE
SUPPORT
FINISHED FLOOR

- 3 -
7302302-100 Rev. A (6/17)
3
4
INSTALLING LAVATORY TO CONSOLE
INSTALLATION OF TOWEL BAR (OPTIONAL)
• Loosely attach the lavatory to the wall at the anchor locations and
level lavatory slab to console. Fig. 1.
• Insert rubber well nuts into mounting hole on front underside of lavatory . Fig. 2.
• Insert the console under the lavatory. Ensure that the lavatory sits evenly
against console and mounting bracket on front console legs align with
mounting holes on lavatory. Fig. 1.
• Level lavatory side to side and front to rear.
• Securely attach console to lavy by inserting screws and washers through bracket
on front legs into well nuts on front underside of lavatory. Fig. 2.
NOTE: Lavatory weight should be held by wall , NOT console.
• Securely tighten lavatory mounting nuts.
DO NOT OVER-TIGHTEN MOUNTING HARDWARE
OR LAVATORY MAY BE DAMAGED!
• Using same lavatory mounting holes with well nuts in the step above, align towel bar
mounting holes below console bracket mounting holes.
• Insert and tighten screws until towel bar is secure (do not overtighten).
TOWEL BAR
SCREW
WELL NUT
WASHER
LAVATORY
MOUNTING
SURFACE
LAVATORY TO WALL ANCHORS
LOCATION 4 PLACES
*SEE
ROUGH-IN
FINISHED
FLOOR
In the United States:
DXV
One Centennial Avenue
Piscataway, New Jersey 08855
Attention: Director of Customer Care
For residents of the United States, warranty
information may also be obtained by calling
the following toll free number: [phone]
www.DXV.com
In Canada:
DXV
5900 Avebury Road
Mississauga, Ontario
L5R 3M3
Canada
Toll Free: 1-800-387-0369
Local: 905-306-1093
Fax: [phone]
www.DXV.ca
In Mexico:
DXV
Via Morelos 330
Col. Santa Clara Coatitla
Ecatepec, Estado de México 55540
Toll Free: 01-800-8391200
www.DXV.mx
FIGURE 1
FIGURE 2
SCREW
CONSOLE
WELL NUT
WASHER
LAVATORY