dynarex Bariatric Shower Chair User manual

Reorder No. 10321
R181121
Bariatric
Shower Chair
LIMITED LIFETIME
WARRANTY
Your Dynarex product is warrantied to be free of defects
in materials and workmanship for the lifetime of the
product for the original purchaser. This item was built to
exacting standards and carefully inspected prior to
shipment. This Limited Lifetime Warranty is an
expression of our confidence in the materials and
workmanship of our products and our assurance to the
consumer of years of dependable service.
The Warranty shall not apply under the following
conditions: problems arising from normal wear; problems
arising from failure to adhere to the product instructions;
problems arising from misuse, negligence, accident or
improper operation, maintenance or storage; problems
arising from modifications or unauthorized repairs, parts
or attachments; products where the serial number has
been removed or defaced; problems with non-durable
components, such as rubber accessories, casters, and
grips, which are subject to normal wear and need
periodic replacement. Dynarex shall not be liable for any
consequential or incidental damages whatsoever.
Dynarex shall repair or replace defective products at its
option. The foregoing warranty is exclusive and in lieu of
other express warranties, if any, including the implied
warranties of merchantability and fitness of a particular
purpose. The remedy for any violation of the implied
warranty shall be limited to repair or replacement of the
defective product pursuant to the terms contained herein.
SYMBOL GLOSSARY
For an explanation of symbols
used in Dynarex packaging, visit
dynarex.com/symbols.php
Manufactured for: Dynarex Corporation
10 Glenshaw Street • Orangeburg, NY 10962
USA • www.dynarex.com
Made in China

Weight capacity 500 lb. (226 kg)
PARTS LIST
ASSEMBLY INSTRUCTIONS
1. Lay the chair base with the seat surface facing down
and the leg sockets facing up.
2. Insert chair leg into the leg socket. Secure the leg in
place using the locking collar pin. Be sure the locking
collar pin goes through the tubing and protrudes on
the opposite side.
3. Repeat step 2 with the other three legs.
4. Turn chair upright.
5. Insert the L-shaped back support tube into the back
sockets. Ensure that the brass push-pin “snaps”
through the hole.
1. Inspect all parts for shipping damage before
assembly. If there is shipping damage – DO NOT
USE. Contact dealer/carrier for further instructions.
2. Make certain that the locking collar pin fully
protrudes through the same respective holes of
each leg extension. This will ensure that the leg
extensions are securely locked in position and an
even height is achieved.
3. Ensure ALL screws, nuts and/or bolts are tightened.
4. Check the rubber tips on the leg extensions for rips,
wear or if they are missing. Immediately replace any
or all if any of these imperfections exist.
5. All four leg extensions with rubber tips MUST touch
the floor simultaneously.
6. DO NOT stand on chair.
NOTE: To maintain the beauty of the original finish,
clean with mild soap and rinse with warm water.
Wipe bath seat dry after each use.
WARNING
Chair Base
Leg
Socket
Back
Socket
Chair Back
4 LegsL-Shaped Back
Support Tube
4 Locking
Collar Pins
ADJUSTING LEG HEIGHT
1. To adjust leg height, remove locking collar pin, set
leg to desired height and return locking collar pin into
adjustment hole. Make sure locking collar pin clicks
into place. Repeat for remaining legs.
NOTE: Make sure all legs are set to the same
height.
2. Make sure legs are locked into place by pushing
down on or pulling legs.