dynarex 10462 User manual

Reorder No. 10462
Manufactured for: Dynarex Corporation
10 Glenshaw Street • Orangeburg, NY 10962
USA • www.dynarex.com
Made in China
SYMBOL GLOSSARY
For an explanation of symbols
used in Dynarex packaging, visit
dynarex.com/symbols.php
LIMITED LIFETIME WARRANTY
Your Dynarex Product is warrantied to be free of defects
in materials and workmanship for the lifetime of the
product for the original consumer purchaser. This item
was built to exacting standards and carefully inspected
prior to shipment. This Limited Lifetime Warranty is an
expression of our confidence in the materials and
workmanship of our products and our assurance to the
consumer of years of dependable service.
The Warranty shall not apply under the following
conditions:
problems arising from normal wear; problems arising
from failure to adhere to the product instructions;
problems arising from misuse, negligence, accident or
improper operation, maintenance or storage; problems
arising from modifications or unauthorized repairs, parts
or attachments; products where the serial number has
been removed or defaced; Problems with non-durable
components, such as rubber accessories, casters, and
grips, which are subject to normal wear and need
periodic replacement. Dynarex shall not be liable for any
consequential or incidental damages whatsoever.
Dynarex shall repair or replace defective products at its
option. The foregoing warranty is exclusive and in lieu of
other express warranties, if any, including the implied
warranties of merchantability and fitness of a particular
purpose. The remedy for any violation of the implied
warranty shall be limited to repair or replacement of the
defective product pursuant to the terms contained
herein.
R180131
Half Length
Bed Rail

MOUNTING INSTRUCTIONS RAIL OPERATION
WARNING
FIGURE 1
Read instructions carefully before installing.
Before use, ensure that the Bed Rail is assembled and
installed as described, that all attaching hardware is
securely tightened, and that the Bed Rail is securely in
place; inspect frequently to ensure that all attaching
hardware is securely tightened, and that the Bed Rail is
securely in place.
DO NOT place two bed rails on the same side of
the bed.
When installing bed rail, only place one rail on bed
per side.
Incorrect mounting may cause injury or death.
DO NOT use the Bed Rail as a handle for getting into or
out of bed; this could result in personal injury and
damage to the Bed Rail.
DO NOT exert side pressure on the Bed Rail; this could
deform or break it.
DO NOT use the Bed Rail as a push handle for moving
the bed; this could deform or break it.
KNOB
FIXED CLAMP JAW
BED FRAME RAIL
MOVABLE CLAMP JAW
1. Attach the bed rail to the frame of the moving head
deck. DO NOT attach to the fixed bed frame.
2. While holding the rail on an angle, slide the rail so
that the bottom edge of the bed frame sits inside the
fixed clamp jaw.
3. Slide the movable clamp jaw over the top of the
frame. Ensure that the movable clamp jaw at the top
of the mechanism attaches to the top edge of the bed
frame, and the bed frame sits between the clamp
jaws. (Figure 1)
4. Tighten knob to secure it into place.
To Raise Bed Rail: Pull out retainer bar, raise rail to
highest position, and release retainer bar, ensuring that
rail is securely trapped by retainer hooks.
To Lower Bed Rail: Raise rail slightly to release retainer
hooks, pull out retainer bar, lower rail and release
retainer bar.