e-con Systems Cocoon Camera Board Instructions for use

Cocoon Hardware User Manual 05-Jun-2015
www.e-consystems.com | Subject to changewithout notice Page 1 of 10
e-con Systems India Pvt Ltd
RISHABH INFO PARK,
RR Tower –IV, 7th Floor,
Super A-16 & A-17, Thiru-Vi-Ka Industrial Estate,
Guindy, Chennai - 600 032.
www.e-consystems.com
Cocoon Camera Board
Hardware User Manual
Revision 1.0
Friday, June 15, 2015

Cocoon Hardware User Manual 05-Jun-2015
www.e-consystems.com | Subject to changewithout notice Page 2 of 10
Contents
Contents ................................................................................................................................2
1 Revision History...................................................................................................................3
2 Introduction .........................................................................................................................4
3 Handling Procedure .............................................................................................................4
4 Conclusion ........................................................................................................................10

Cocoon Hardware User Manual 05-Jun-2015
www.e-consystems.com | Subject to changewithout notice Page 3 of 10
Cocoon –Camera Board
1 RevisionHistory
Rev
Date
Description
Author
1.0
5–June–2015
Initial Draft
Camera Team

Cocoon Hardware User Manual 05-Jun-2015
www.e-consystems.com | Subject to changewithout notice Page 4 of 10
2 Introduction
Cocoon Board (Camera board connected with Cocoon Adaptor board) interfaced with Wandboard
through a 33-pin flex cable. The flex cable connecting Cocoon camera Adaptor board and
Wandboard is 15 cm in length.
This document explains how to interface the Cocoon Camera board and Adaptor board with
Wandboard development Kit. The scope of this document is limited to a brief description of the
steps to be followed while connecting the board with Wandboard.
3 HandlingProcedure
The following figures explain how to connect the Cocoon Adaptor board with Wandboard.
Figure 1: Cocoon Adaptor Board
Figure 2: FPC Connector Unlocked Position

Cocoon Hardware User Manual 05-Jun-2015
www.e-consystems.com | Subject to changewithout notice Page 5 of 10
Figure 3: 33 Positions FPC Cable
Figure 4: FPC cable Insertion

Cocoon Hardware User Manual 05-Jun-2015
www.e-consystems.com | Subject to changewithout notice Page 6 of 10
Figure 5: Cocoon Camera Board
Figure 6: Connecting the Camera Board with Adaptor Board

Cocoon Hardware User Manual 05-Jun-2015
www.e-consystems.com | Subject to changewithout notice Page 7 of 10
Figure 7: Front view of Wandboard Development Kit
Figure 8: Rear View of Wandboard Development Kit

Cocoon Hardware User Manual 05-Jun-2015
www.e-consystems.com | Subject to changewithout notice Page 8 of 10
Figure 9: A close view of MIPI connector in Wandboard
Figure 10: Connecting the FPC cable with Wandboard

Cocoon Hardware User Manual 05-Jun-2015
www.e-consystems.com | Subject to changewithout notice Page 9 of 10
Figure 11: Cocoon Board connected with Wandboard
Figure 12: Connecting 5V Power to Wandboard
After connecting the Cocoon camera and adaptor board to Wandboard, insert the SD card
(the SD card should contain the camera test application) and then connect the DC power jack.
Also, connect HDMI monitor through the HDMI cable provided and USB mouse.

Cocoon Hardware User Manual 05-Jun-2015
www.e-consystems.com | Subject to changewithout notice Page 10 of 10
4 Conclusion
This document describes how to connect Cocoon Camera board and Adaptor board to
Wandboard and how to get it working.