Eaton CDWA-01/3 Series Manual

1
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria MA_CDWA_01.indd / 07.2019b / IL019237ZU / 136211205
© 2019 by Eaton Industries (Austria) GmbH, www.eaton.eu/documentation All Rights Reserved / Printed in Austria
www.eaton.com/recycling
Door/Window Sensor
CDWA-01/3..
+40
0
Technical Data / Technische gegevens / Tekniske data /
Technische Daten / Technická data
Power supply Battery, CR2 3 Vdc
Battery Service Life >5 years (TYP)
Behavior sensor ON if closed (factory default)
ON if open (selectable)
Max. Distance Fe < 10 mm (sensor/magnet)
None Fe < 15 mm (sensor/magnet)
Button Operation Set sensor behavior
LED Multi-Color operation status
Dimensions
Magnet 55 x 12 x 12 mm (H x W x D)
Sensor 103 x 19 x 29 mm (H x W x D)
RF 868.3 Mhz (xComfort compatible)
Max. RF power 25 mW (ERP)
Battery CR2
Long battery service life
1x 1x 1x 5x
Multi-Color Status LED
or
Selectable sensor behavior:
= ON
= ON
2x 2x
Instruction Leaflet
Montageanweisung
Notice d’installation
Instrucciones de montaje
Istruzioni per il montaggio

Инструкция по монтажу
Montagehandleiding

Montagevejledning
Οδηγίες εγκατάστασης
Instruções de montagem
Monteringsanvisning
Asennusohje
Návod k montáži
Paigaldusjuhend
Szerelési utasítás
Montāžas instrukcija
Montavimo instrukcija
Instrukcja montażu
Navodila za montažo
Návod na montáž
Монтажни инструкции
Instrucţiuni de montaj
Upute za montažu
Kullanma Talimatı
Инструкција за монтажу
Intruksjonsblad
Монтажна інструкція
ت ا ة 
868.3 MHz
IP20
Colors Type Designation
Warm white CDWA-01/3a
Bright white CDWA-01/3b
Grey CDWA-01/3c
Brown CDWA-01/3d
MRF Version 2.64
RM Version V41c
SHC-RF Version 2.21
ECI-RF Version 2.10
USB-RF Version 2.10
www.eaton.eu/xcomfort
136211205.indd 1136211205.indd 1 15.07.2019 09:22:3415.07.2019 09:22:34

2
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria MA_CDWA_01.indd / 07.2019b / IL019237ZU / 136211205
© 2019 by Eaton Industries (Austria) GmbH, www.eaton.eu/documentation All Rights Reserved / Printed in Austria
www.eaton.com/recycling
12a 2b
1a 23
3
1b
CR2 Lithium, 3V
1
2
3
5 mm 10 mm (0-20 mm)
<10 mm Fe
<15 mm Fe
Sensor
Magnet positioning / Positionering magneet / Plassering av magneten / Positionierung des
Magneten / Umístění magnetu
Mounting / Montage / Montering / Montage / Montáž:
Magnet
Change contact type / Contact type wijzigen / Endre kontakttype / Kontakttyp ändern /
Změnit typ kontaktu
1
2
3
1
2
3
< 0.5 sec
AB<->
LED:
White /:Wit / Hvit / Weiß / Bílý
-> ON / Aan / PA /
Ein / Zapnuto
ON / Aan / PÅ /
Ein / Zapnuto
Blue / Blau / Blå / Blau / Modrý:
->
Mode A
Mode B
136211205.indd 2136211205.indd 2 15.07.2019 09:22:4915.07.2019 09:22:49

3
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria MA_CDWA_01.indd / 07.2019b / IL019237ZU / 136211205
© 2019 by Eaton Industries (Austria) GmbH, www.eaton.eu/documentation All Rights Reserved / Printed in Austria
www.eaton.com/recycling
PROG
PROG
2x
PROG
Mode A
Mode B
Assign Sensor in Basic Mode / Sensor in Basic Mode toewijzen / Tilknytte i Basic Mode /
Zuweisen des Sensors im Basic Mode / Přiřadit v základním režimu
Remove Sensor in Basic Mode / Sensor in Basic Mode verwijderen / Fjerne i Basic Mode /
Löschen des Sensors im Basic Mode / Odstranit v základním režimu
LED during operation / LED tijdens bedrijf / LED under drift / LED im Normalbetrieb / LED
během provozu
During 20 sec after status change / Gedurende 20 seconden na statuswijziging / I løpet av 20 sek
etter statusendring / Nach Statusänderung für 20 Sekunden / Během 20 sekund po změněstavu
PROG
PROG
5x
PROG
Mode A
Mode B
At status change, when activated in MRF / Bij statusverandering, indien geactiveerd met MRF / Ved
statusendring, når aktivert med MRF / Bei Statusänderung wenn mit MRF aktiviert / Při změněstavu,
když je aktivován MRF
Blue flashing
Blauw knipperend
Blå blinkende
Blaues Blinken
Modrá blikání
No assignment
Geen toekenning
Ingen oppgave
Keine Zuordnung
Žádná přiřazení
Orange flashing
Oranje knipperend
Oransje blinkende
Oranges Blinken
Oranžová blikání
Bad RF communication
Slechte RF-communicatie
Dårlig RF-kommunikasjon
Schlechte RF-Kommunikation
Špatná RF komunikace
Red steady
Rood continue
Rød, permanent
Rotes Dauerlicht
Červená stabilní
Replace battery
Vervang de batterij
Bytt batteri
Batterie wechseln
Vyměnit baterii
Red flashing
Rood knipperend
Rød blinkende
Rotes Blinken
Červená blikání
No RF communication
Geen RF-communicatie
Ingen RF-kommunikasjon
Keine RF-Kommunikation
Žádná RF komunikace
Green short flash
Groene korte flits
Kort grønt blink
RF communication okay
RF-communicatie in orde
RF-kommunikasjon ok
Grünes kurzes Blinken
Zelené krátké bliknutí
RF-Kommunikation in Ordnung
RF komunikace je v pořádku
136211205.indd 3136211205.indd 3 15.07.2019 09:22:5015.07.2019 09:22:50

4
Eaton Industries (Austria) GmbH, Eugenia 1, 3943 Schrems, Austria MA_CDWA_01.indd / 07.2019b / IL019237ZU / 136211205
© 2019 by Eaton Industries (Austria) GmbH, www.eaton.eu/documentation All Rights Reserved / Printed in Austria
www.eaton.com/recycling
Affixing date of CE mark:
2019
Doc.Id.:
CDWA-013x_010419
Senior Vice President Director Quality
General Manager & Systems
Friedrich Schröder
Fernando Ceccarelli
Declaration of Conformity
We, EATON Industries (Austria) GmbH
3943 Schrems, Eugenia 1
Austria
declare under our sole responsibility as manufacturer that the product (family)
Eaton - Door Window Sensor
CDWA-01/3x
(the declaration of conformity applies to all
listed types within our actual product catalogue)
provided that it is installed, maintained and used in the
application intended for, with respect to the relevant manufacturer’s
instructions, installation standards and “good engineering practices”
complies with the provisions of Council directive(s):
RED Directive 2014/53/EU
RoHS Directive 2011/65/EU
based on compliance with following standard(s):
EN 301489-3 V2.1.1, EN 300220-2 V3.2.1,EN 63044-5-1:2018, EN
63044-5-2:2017, EN 62368-1:2014, EN 62479:2010, EN 50581:2012
01.04.2019
136211205.indd 4136211205.indd 4 15.07.2019 09:22:5115.07.2019 09:22:51