Eco-Smart AL13-8FT-RGBWW-1-A User manual

8 ft. LED Color Changing Rope Light
Use and Care Guide
Installation
PREPARING TO EXTEND THE
ROPE LIGHTS CONNECTING THE ROPE LIGHTS MOUNTING THE ROPE LIGHTS
Ensure all rope lights are
unplugged before adding the
additional rope light (A) to the series.
Connect the last rope light in the
series and the extension rope.
light (A) together and ensure the
connectors are tightly secured.
Attach the end cap (1) to the last rope
light in the series and ensure the
connection is secure.
Remove the end cap (1) from the last
rope light in the series by turning
counterclockwise.
Remove the power cord (2) from additional
extension rope lights (A).
Extend up to 96ft (29.2 m) maximum. Use only
the following Commercial Electric rope light
extension segments: 1005580337
or 1005580338.
Item # 1005580338
Model # AL13-8FT-RGBWW-1-A
Make sure the distance between two
lines of rope light is at least 1/2in. (12 mm).
Mounting clips should be evenly spaced
and be a maximum of 3 ft. (0.91 m) apart.
Insert the screw (C) through the
opening in the mounting clip (B).
Screw the mounting clip (B) into
position at the installation location.
Place the rope light (A) securely into
the mounting clip (B).
WARNING: Do not install the rope light within
16 ft. (4.87 m) of pool or spa. Do not install rope
lighting in cabinets, tanks, or enclosures of any kind.
WARNING: This product has a polarized plug (one
blade is wider than the other) as a feature to reduce
the risk of electric shock. This plug will t in a
polarized outlet only one way. If the plug does not t
fully in the outlet, reverse the plug. If it still does not t,
contact a qualied electrician. Never use with an
extension cord unless the plug can be fully inserted.
Do not alter the plug.
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
FCC WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Any changes or modications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
WARNING: When using this product outdoors,
basic safety precautions should always be followed
to reduce the risk of re, electric shock, and
personal injury.
WARNING: Do not cover this product as the
covering may cause the exible light to overheat
and either melt or ignite.
WARNING: Do not puncture, cut, shorten, or
splice the exible lighting.
WARNING: Do not use if there is any damage to
the light or cord insulation. Inspect periodically.
CAUTION: All units must be unplugged before
you add additional segments. Only use segments
recommended by the manufacturer of this lighting
system.
CAUTION: Ensure all connections and the end
cap on the last segment are tightly secured to
prevent the entry of water.
WARNING: Secure the rope lights using only the
mounting clips provided. Do not secure this product
with staples, nails, or similar objects that may
damage the insulation.
WARNING: Do not submerge the exible light in
liquids or use the product in the vicinity of standing
water or other liquids.
WARNING: Do not mount or secure the rope
light in a manner than can cut the outer jacket or
damage the cord insulation. Inspect the rope light
carefully before use and discard any rope lights
that have a broken outer jacket, loose connections,
or frayed wire insulation.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
The RF remote controller included utilizes a 3V CR2025 battery; only replace with same battery
type. Please dispose of batteries properly. Batteries are not a toy! If swallowed, contact local
emergency services immediatley.
Ground Fault Circuit Interrupter (GFCI) protection should be provided in the circuits
or outlet to be used for outdoor use. Receptacles are available that have built-in GFCI
protection.
Only use outdoor extension cords such as typ SW, SOW, STW, STOW, SJW, SJOW, SJTW,
or SJTOW. This designation is marked on the wire of the extension cord.
The rated voltage for this product is 120VAC, 60Hz, 9.6W, 0.1A.
Do not operate this product with the exible light tightly coiled.
Do not route the cord or exible light cable through walls, doors, windows, or any
similar part of a building structure.
Do not subject exible lighting to continous exing.
Do not exceed the maximum extension length in feet permitted by the marking. The
maximum extension length for this rope light is 96ft. (29,2 m).
D - Handheld Remote Control x 1
A - 8ft. Rope Light x 1 B - Mounting Clip x 4 C - Screw x 8 E - 3V CR2025 Battery
Please contact 1-877-527-0313 for further assistance.
HOMEDEPOT.COM/ECOSMART

Disconnect the power before replacing the fuse.
Grasp the plug (1) on the primary rope light and remove from the receptable or other outlet device. Do not unplug by pulling on the cord.
Slide the fuse access cover (2) towards the prongs of the plug (3) to open.
Carefully remove the old fuse (4) and replace with a 5-Amp 125-Volt fuse.
Close the fuse access cover (2) by sliding to the original closed position.
R G B W
Operation
Button Description
Switch on the rope light.
Switch off the rope light.
Decrease the speed in
flash, strobe, fade, and
smooth modes.
Increase the speed in
flash, strobe, fade, and
smooth modes.
Strobe Mode: The color
changes every 3 seconds.
Fade Mode: The color
changes slowly.
Smooth Mode: The color
changes slightly faster
than Fade Mode.
Flash Mode: Each color
flashes quickly.
Select from 16 colors
with adjustable
brightness.
Button Description Button Description
To use the handheld remote control for ON/OFF control and color control, remove the plastic tab from the battery door before use.
To replace the remote control’s battery, follow the directions on the back of the remote control to slide the battery drawer out.
Replace the battery (+ side up) and slide the battery drawers back in place.
Maximum recommended remote control distance is 16.4 ft. (5 m)
The rope light can also be controlled using the in-line controller attached to the power cord.
WARNING: Risk of re. The plug on the main
rope light contains an electrical fuse as a safety
feature. Do not remove or replace this plug. Do not
use the light if the plug is damaged.
Button Description
Press the button to toggle through 16 color options, Fade Mode with 16 color options, Smooth
Mode with 16 color options, Strobe Mode with 16 color options, Flash Mode with 16 color
options, then OFF.
1-877-527-0313 or visit www.HomeDepot.com
RV2045
Made in China
Please contact 1-877-527-0313 for further assistance.
SAVE THESE INSTRUCTIONS FOR FUTURE USE
HOMEDEPOT.COM/ECOSMART
WWW.HOMEDEPOT.COM/ECOSMART
Questions, problems, missing parts? Please call ECOSMART Customer Service
8 a.m. - 7 p.m., EST, Monday - Friday and 9 a.m. - 6 p.m., EST, Saturday
1-877-527-0313